It is possible that Dell 5090 oem Q570 chipset has 1x16 PCIe gen 4 lanes of cpu all wired to PCIe 4.0 x 16 graphics slot, and onboard M.2 slot connected to 4 PCIe 3.0 of chipset. Dell only validated PCIe gen 3 nvme ssd in this model which may speak for that. We have seen in the past Dell oem board m.2 is often curtailed to lower end spec (such as XPS 8900 M.2 was only x1). If this is the case for 5090, you can try use a pcie4.0 nvme adapter to install the ssd in the x16 slot, if you do not currently have a dedicated graphics card in it already.
It's really depends on how Dell (or their MB subcontractor) have implemented the M.2 slot, 5090 are cheap version with only one M.2 for storage (vs 7090 Tower - which has 2) therefore a lot of high-end features are not available.
If it's hooked into CPU PCIe bus - then it can go up to Gen4 (depending on CPU as described below), if it's wired to chipset (Q570) then it's Gen3 as maximum (per Intel' specification)
Also depends on your CPU PCIe lanes, Gen 11 supports Gen4 PCIe, Gen 10 CPUs don't (if I remember correctly)
Thank you Kudos for your reply, my disk is hooked directly into MB-CPU NVME PCIe bus, its I5 Gen 11, so it should be PCIe Gen 4, its built on the main board, CrystalDiskInfo show that current mode is PCIe 3.0 x4 and the supportd mode is PCIe 4.0 x4, so how can i enable the transfer mode to be PCIe 4.0 x4, do i need BIOS update? special settings, driver, ...etc ?? really dont know why it cant be boosted to be PCIe 4.0 x4!
If your cpu and chipset even support it, the 1st on-motherboard M.2-NVMe slot is usually PCIe-4.0 x4 lanes (aka 4x4). You use this for your C-Drive.
However, the 2nd on-motherboard slot (and others) are often just PCIe-3.0 x4 lanes ... but that is still really fast ... like 3500=r/w=3000 .
Dell Rockstar
Microsoft Windows and Apple iOS Developer (Retired) - Like many of you, I can appreciate a good game-engine. - I answer questions here, but I'm not a Dell employee. - Consider giving posts you like a "thumbs-up" - Posting models-numbers and software versions speeds trouble-shooting. - Click "Mark as Accepted Answer" on any post that answers your question best.
Adding to what reddps630 with screengrabs. Could be a little confusion as an m.2 2280 gen4 drive is listed, but slots are gen3. ? Probably would have to take MB as all Gen3.
redxps630
11 Legend
•
16434 Posts
•
83185 Points
817
1
Posted September 1st, 2022 22:00
It is possible that Dell 5090 oem Q570 chipset has 1x16 PCIe gen 4 lanes of cpu all wired to PCIe 4.0 x 16 graphics slot, and onboard M.2 slot connected to 4 PCIe 3.0 of chipset. Dell only validated PCIe gen 3 nvme ssd in this model which may speak for that. We have seen in the past Dell oem board m.2 is often curtailed to lower end spec (such as XPS 8900 M.2 was only x1). If this is the case for 5090, you can try use a pcie4.0 nvme adapter to install the ssd in the x16 slot, if you do not currently have a dedicated graphics card in it already.