By default, the value of WS-MAN Service Check Timeout is set to 1 second with a hard-coded number of retries. What is recommended is to increase the timeout value higher than the default to avoid these connection failures.
Let me know if this helps.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
What troubleshooting steps have you taken so far? I'd verify that the host is up and that the iDRAC is responsive. This can be done through CLI by issuing a simple command like 'racamd getsysinfo.' I'd also restart the appliance, if you haven't already. My understanding is that you've verified the network configuration, so these steps may help, if the issue isn't config related.
I have the same problem. Many servers generate "CDEV6131, Unable to perform the operation on the device because connection with the device is lost" at regular intervals, producing a lot of mails. We have updated from version 3.4.1 (Build 24) to 3.8.1 (Build 16). We didn't have the problem before. Is there a solution for this? I have rebooted all of our three appliances so far.
In their day, after several conversations and open threads with support, they told us the following alternatives:
1. Install hotfix 3.5.1 (which removes or reduces the false alert) 2. Wait for the release 3.6 that comes out in the middle of May. 3. Or ignore these alerts, creating an alert policy
but I see that you are already in a higher version ...
You can try to reset iDRAC and make sure iDRACs firmware have up to date. To help decrease CDEV6131 events, one can: Retries and timeouts configured under device Discovery configuration in Additional Settings. have it change retries from 3 to 4.
*Apart from that I could reach the information whilst reviewing the issue is that these repeated occasions will be addressed in the 3.9 release with an ETA of 1st Quarter of 2022.
Hope that helps!
DELL-Erman O
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
I can share your feedback and see if the relevant team can replicate the behavior, but I would recommend testing 3.9. As Erman had mentioned, it should be available early 2022.
In our environment we're having the same issues. And they are basically all related to IOMs (in our case MX9116n's, MX7116n's and MXG610's). Nothing in our case is related to iDRAC. Also we tend to see stuff "disappear". If I run a CMC discovery of our MX7000 chassis groups I end up with 90 devices and this tends to drop during the day to about 77/78 and we're not removing anything.
We are having the same issue. Is it possible to ignore a specific Message ID? From what I can see if we turn off the Devices then we won't get messages if other errors come up?
DELL-Chris H
7 Practitioner
•
9682 Posts
•
48046 Points
0
0
Posted April 9th, 2025 20:29
By default, the value of WS-MAN Service Check Timeout is set to 1 second with a hard-coded number of retries. What is recommended is to increase the timeout value higher than the default to avoid these connection failures.
Let me know if this helps.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!