UNSOLVED

liudr

updated

12 years ago

L

liudr

11 Posts

0

34857

June 10th, 2014 23:00

Dell venue 8 pro active digitizer manual? How to adjust?

I just got my active digitizer. It is disappointing. This one is A02 version, so not the old A00. I have to press down so hard to make a scratch on either Paint of MS OneNote. I could push in the tip or pull it out a bit. Seems pushing it in helps but it's just so hard. I've used a gateway tablet PC with active digitizer before. I don't remember ever having to press so hard to write. I've even written a program on that machine to capture my strokes for replay. This dell is so difficult to use. How do I adjust its sensitivity? Is there a way to check my firmware version? Any help is appreciated!
  • Mikerman

    1 Rookie

    •

    915 Posts

    791

    0

    Posted June 11th, 2014 02:00

    As far as I'm aware, no general way to adjust the sensitivity, by the user. However, there are controls in some of the various programs, such as to turn off pressure sensitivity (recommended to do in some programs). There is a Dell panel touch firmware update from early this year, to improve stylus performance. Have you applied it? Otherwise, you might want to call Dell--perhaps it is a defect issue.
  • liudr

    11 Posts

    791

    0

    Posted June 11th, 2014 09:00

    Is there any manual for this $35 <ADMIN NOTE: Profanity removed as per TOU> ? I don't know how to check firmware version?! I downloaded from dell.com all latest stuff. One of them flashed my BIOS from A04 to A05, I think. That didn't help too much. I saw videos of people using their tablets and this pen to draw lines etc but I just can't. I have to press so hard that I can't do it anywhere other than on a flat desk top and pressing hard. The tip comes out if I pull it. It may help with some pressure adjustment but I am not getting it to work to my needs. The one page thing that came with the thing has no text, just a few dumb features. There is no way to configure the two buttons either, any help?

  • Mikerman

    1 Rookie

    •

    915 Posts

    791

    0

    Posted June 11th, 2014 12:00

    No manual or guide, unfortunately (and people have been asking Dell). The buttons, at least at present, are not user-configurable; their use is set by the program (including Windows itself). Again, if you have to press down so hard, the pen may be an issue, for Dell to replace.
  • liudr

    11 Posts

    791

    0

    Posted June 12th, 2014 16:00

    Dell is getting too cheap. I've purchased 4 dell laptops in the past 1.5 years. My last purchase has been very disappointing. Had to get hard drive and mobo replaced right out of the box. Now its palm rest will cut your wrist since the repair tech has green hands and couldn't properly close the palm cover against the rest of the laptop body. The other three all work fine and don't cut your wrist. Before this purchase I got another dell, which came in with a screen so warped that I had to return it. This one I got last has the screen glass glued to the back of the screen instead of screwed to it. Its glue is coming undone at places, only after 3 months of using on a desktop. I travelled with it once. All 5 (one I returned) were priced the same by the way.