No bootable device discovered after Samsung SSD installed in Dell 3250 Inspiron.
Just installed a Samsung 850 EVO Pro into a brand new Dell 3250. Get the no bootable device found error. Cloned the original HDD using Samsung migration software. Anyone else having the same problem?
Yes the Samsung shows up in BIOS as the only drive and as the first drive in the boot order. It has been the only drive connected as the original WD has been removed.
When the Samsung SSD would not boot, I removed it and reinstalled the original WD drive and it boots up fine again.
Next question: was the original hard drive set in RAID mode? If so, you'll need to do a clean install to shift the system to AHCI mode (and if it's set for windows boot manager, you won't see the drive in the boot list until that's done).
Yes. I have the same exact problem with a Dell XPS 9343. I installed the new Samsung 850 EVO and the problem started. The system does not see the hard drive when I tried to boot up. I ran the Dell diagnostics and it says "no hard drive found'. Continuing to reboot by turning the power off and on eventually it boots up and everything works as expected. Sometimes it boots on the first try and sometimes it takes 4-5 tries. Normally it takes 2. ...I have messed with this for a couple years now and noone has an answer. Dell has been "O" help on this.
ejn63
11 Legend
•
87469 Posts
•
321256 Points
4808
0
Posted March 19th, 2017 04:00
1. Does the UEFI setup see the drive, and if so,
2. Is it showing up in the UEFI boot manager and,
3. If not, did you make sure you removed the original drive BEFORE trying to boot the cloned one the first time?