I currently have a XPS 400 with a single 160GB HD. If I want to migrate to RAID 1 I would need to install another SATA HD, when I start up he computer I will have to configure the drive in the BIOS setup, and then I would run the Intel Martrix Storage Manager to transfer the data to the new drive.
Now some other questions.
Do I have to use the same size HD? If I currently have a 250 GB SATA HD anvailable, can I use it? I understand that some of it would be wasted space, since the other drive is only 160G.
Will migrating the system to RAID 1 cause any problems with upgrading to Windows Vista when it is available?
Normally you should have the same size and model, but having a larger model should work. When you get done, your RAID should mirror on to the two drives. You should have some free space that you may be able to allocate to a Non RAID partition at the end. Not sure how this will work for sure because in my case I had two matched drives.
On my XPS gen2, i only had to install the drive. The BIOS reconized the drive since with SATARAID set to YES in the BIOS both of my SATA ports were enabled. NOt sure how it work on a 4 Port system like yours.
After starting the system, I opened the control panel, open up the Intel Storage Manager and used that to migrate to RAID 1. I DID NOT use CTL I to set it up in the BIOS. I think you manual may go into more detail. On my XPS gen2 the documentation was slim or none.
As far as the next gen windows should be no issue, the RAID volume should look like one logical disk to Vista. I am sure you need updated drivers for Vista.
My response assumed that all the factory setting are in place and the system has not be reloaded. At least in the case of my XPS gen 2, the system was RAID ready, and I do beleive Dell is still shipping the system configured like mine was.
TomXPS
1310 Posts
111
0
Posted January 12th, 2006 19:00
Normally you should have the same size and model, but having a larger model should work. When you get done, your RAID should mirror on to the two drives. You should have some free space that you may be able to allocate to a Non RAID partition at the end. Not sure how this will work for sure because in my case I had two matched drives.
On my XPS gen2, i only had to install the drive. The BIOS reconized the drive since with SATARAID set to YES in the BIOS both of my SATA ports were enabled. NOt sure how it work on a 4 Port system like yours.
After starting the system, I opened the control panel, open up the Intel Storage Manager and used that to migrate to RAID 1. I DID NOT use CTL I to set it up in the BIOS. I think you manual may go into more detail. On my XPS gen2 the documentation was slim or none.
As far as the next gen windows should be no issue, the RAID volume should look like one logical disk to Vista. I am sure you need updated drivers for Vista.
My response assumed that all the factory setting are in place and the system has not be reloaded. At least in the case of my XPS gen 2, the system was RAID ready, and I do beleive Dell is still shipping the system configured like mine was.
Good luck with your RAID conversion.