UNSOLVED

JoelCress

updated

19 years ago

J

JoelCress

1 Rookie

•

13 Posts

0

2930

July 11th, 2007 23:00

Dimension XPS T800r

I purchased a 200 gb hard drive to put as a slave drive in my older Dimension XPS T800r. Unfortunately, the Ultra IDE only recognizes 130 gb or so.
 
If I connect this directly to the motherboard instead of the PCI board, will it recognize the whole 200 gb?  And can I have it as a secondary drive hooked directly up to the mb without an OS on it,  or will it try to default to this as the primary hd?
 
 
 
  • ejn63

    11 Legend

    •

    87469 Posts

    •

    321256 Points

    293

    0

    Posted July 11th, 2007 23:00

    The onboard controller will have the same limitation.
  • korrson

    1 Rookie

    •

    592 Posts

    293

    0

    Posted July 13th, 2007 00:00

    aaa Dimension XPS T series, I had one that served me well. RIP

    But it shipped with Win 98 and that can only see 120GB -125 looking at various googles.
    Read you can make 120GB partitions and then you can see the whole drive.

    But you're limited on speed by the ATA/100 or was it up to ATA/133 for the T800?

    Upgrading to Win XP may let you see those juicy larger hard drives in one chunk but may just slow down the whole machine over the less resource intensive Win98.

    Plus the T series is severely dated and just good for web browsing and email these days. It was just OK for simple photo work but struggled just to play DVDs even after I upgraded to a 1GHz CPU and better video card....

    Message Edited by korrson on 07-12-2007 08:52 PM