UNSOLVED

Geoff Schwenker

updated

20 years ago

0

4783

August 22nd, 2006 19:00

Dell 1815dn Network Issue

I an having network issues with my 1815dn MFP printers. When I put it on a different subnet I can not talk to it any more over the network. The people on the same subnet can talk to the printer and ping it but from different subnets they can not ping or talk to it. Has anybody heard of a solution for this issue?

Thanks

Geoff
  • 217

    0

    Posted August 23rd, 2006 04:00

    Most network printers only work from the computers on the same subnet. If you have two different subnets, it is not going to work unless you have a bridge between both subnets.
  • 217

    0

    Posted August 23rd, 2006 11:00

    I have never had any issue with any printer before and this is the first printer that I have run across that will not communitcate over subnets. All my locations are interconnected with Cisco routers and all location communicate with head office were the servers are located.

    I have a lot of the 1600n MFP printers and have never had any issues with them, but for the 1815dn, I seem to have a lot of issues. First was the Canon issues which was resolved with the recent firmware release and now I have run across this subnet issue.
  • 217

    0

    Posted July 10th, 2007 12:00

    Hi,
     
         I know I'm behind with this but then I don't use Dell equipment.  I'm trying to install the 1815dn on a network running a Netgear router.  I've connected the printer, via the network connection to one of the available ports on the router and when I go into the router's configuration, it doesn't see the printer.  Is there some software that needs to be run to prep the printer?  Consider, I am doing this for someone else who knows nothing about this.  The printer had a label that says "refurbished".  Cursory examination shows that I get a light on the connection from the printer where the cat 5 connection is made but I'm confused as to why it doesn't show on the router.  Although I know very little about the printer, I'm pretty good with routers and this shouldn't be a problem unless I have a glitch with the printer.  Normally, even if there is no other recognition by the router, it will at least see the MAC address.   It's Windows XP Pro and I don't think she has a manual or software for the printer.  Mostly, I think I need to know about initial setup of this printer, particularly with the network.
     
    Thanks...Vince