I am trying to connect our new 3100CN to a small network. Whenever I connect the printer into the network through a 100 Mbps Linksys hub the printer's IP address gets assigned as 169.254.230.201. Way out of the range the DHCP router settings of 192.168.1.100 - 150. However, when I connect the printer to a 10 Mbps hub, the DHCP router assigns a 192.168.1.109 IP address at 10 Mbps half duplex. At this setting sending a color document to the printer takes several minutes to print.
- I am using a Linksys Router with auto DHCP. The router is connected to a cable modem. A linksys hub provides the connection to the Router for the 6 computers and 2 printers (1 being the 3100CN).
Thank you for your response. Unfortunately, by setting the printer's IP manually, either by the web interface or using the printer's panel, the manually set IP address is not recognized by the Router DHCP table and is therefore unreachable through the network.
One of the things that I have done is actually isolate the printers from the file server. I have 2-3000cn printers, a Sonic Wall firewall(router), a file server, DSL modem, 8 workstations, and several switches. Here is how I have setup the network.
1. the Printers are manually assigned IP addresses, the Sonic Wall assigns IP addresses through DHCP and printers are registered as static addresses on the Sonic Wall. The printers are connected to the switches and not through the workstations. This setup works for me because we lost power a couple of times and when the IP addresses were assigned by DHCP the printers somehow could not be found. The printer drivers are manually installed on each workstation including the file server. IT WORKS...
The beauty of this setup is that if the file server is out of service the printers are still available.
You can assign the printers with static addresses on your router so that they are recognized by the network.
I can walk you through this setup if you need additional help. Call me at 509.838.1881.
It sounds like a communications error between the printer and the 100mb hub. The IP address in the 169 range is most likely self-assigned by the printer after it tries to obtain an IP address via DHCP and then fails.
Make sure the Ethernet port settings in the printer are set to "Auto". If it already is, try changing the setting to force it to use "100Base-TX Half Duplex". It sounds like the printer is either forced to 10Base-TX Half Duplex, or the auto-detect in the printer NIC is not sensing the hub correctly.
As an aside, you also might want to consider replacing your hub with a 10/100 switch. An 8 or 12 port unmanaged switch is super cheap, and would give you much better throughput than a hub if you're passing a lot of data inside your LAN.
Gillian75
4 Posts
285
0
Posted January 23rd, 2006 17:00
Thomas