UNSOLVED

bushtor

updated

16 years ago

B

bushtor

31 Posts

0

29310

May 12th, 2011 14:00

Unassign drive to make it hotspare

Hi,

I purchased an additional drive to my MD3000i because I wanted a second hotspare available.  In the PV manager I didn't find a way to add the new drive as an additional hotspare so I thought I had to assign it as a volume first.  Obviously that was wrong so now this new drive is available a empty and free storage.

How do I unassign this drive as volume storage and assign it (or set it up) as a second hotspare?  I'm using the Dell Modular Disk Storage Manager Client.

Thanks a lot for comments on this

regards

Tor

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    1425

    0

    Posted May 12th, 2011 16:00

    When you say:

    ...assign it as a volume first...

    Do you mean you added it to a diskgroup?

    If so, there's no way to make it a hotspare without backing up all your data, destroying all the virtual disks in that diskgroup, then destroying the diskgroup and then recreating it all minus that one drive. After this you can restore your data.

    For the Powervault MD3-series, the rule is that you can grow a diskgroup and/or virtual disk, but you can never shrink one.

  • bushtor

    31 Posts

    1425

    0

    Posted May 13th, 2011 00:00

    Hi,

    It shows up in Disk Group 1 as a separate 'Free capacity' volume, so I assume there is no way back.

    However can I move this drive to another physical slot?  Now it is in slot 13 beside the hotspare and I would like to move it to slot 8 and put in another drive as 2nd hotspare in slot 13.

    How do I correctly add a second hotspare drive to my MD3000i using the management software?

    regards and thanks for the clarification

    Tor

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    1425

    0

    Posted May 13th, 2011 08:00

    By adding a drive to the diskgroup, your raid set got expanded to include the extra drive. This means that all your data in that diskgroup is spread across all the drives in that diskgroup.

    So, if you pull a drive in that diskgroup at this time, the array considers that a disk failure and it will start rebuilding to your existing hotspare. At this time it will also show a fault on the unit that won't be fixable till you put a replacement drive in the slot where you pulled the drive from.

     

    You have 2 choices:

    - spend more money and buy yet another drive to be your hotspare

    - back up all data on the virtual disks in the diskgroup, destroy the virtual disk(s), destroy the diskgroup, recreate the diskgroup without the drive you want to have as a hotspare, recreate the virtual disk(s), reassign them to the server(s), repartition and restore your data.

     

    On an MD3000, to assign a hotspare, you go to the configure tab and look for the "Configure hot spares" option. This is only possible with unconfigured drives (i.e. not part of an existing diskgroup).