It has a PERC 710 mini in it. There are 3x 600GB SAS drives currently in a RAID 5 array.
I am trying to get Windows Server 2008 R2 installed, I have a legit disc with Serer 2008 R2 x64 SP1 included and obviously when I try install it it asks for drivers.
I have downloaded the drivers for the 710 put it on a flash drive, Windows finds it and makes use of it but then states that no new devices could be found.
I used the service tag to get the drivers for the 710 mini, so do not see how the driver could not be the correct one.
So here I am asking for some assistance. I am willing to break the array and recreate it (give me the steps if you'd like, incase I am doing something wrong).
I will try it all. The server use to be live and working fine, there were some issues and the technician who was at the site before me stated it was the RAID controller. Dell came out and replaced the RAID controller as well as cable. I then took over the site and am now left with this. The data on the drives is not yet important so does not matter if it is scrapped.
I managed to resolve my issue - what happened is that the SATA RAID was enabled so Windows wanted drivers for that - as opposed to the PERC controller.
Good morning. Since you have stated the data is not important, lets proceed from there.
Start the server and watch for the Ctrl R prompt. Enter the Ctrl R bios, and under the VD Mgmt Screen, check the status of your array. I think you may find that its a RAID 1 and not a RAID 5, since a RAID 5 requires 3 drives. Arrow down to the Virtual Disk 0, and hit F2; delete the VD. You should have a screen now that shows No Configurations Present! Hit F2, and create a new VD. Select the RAID level you need, if you only have 2 drives, select RAID 1 and hit the TAB key. With the space bar, select your drives and then hit the TAB key till you get to the VD Name. Provide a name for this array and then TAB to Advanced Settings, hit the space bar to select, then TAB down to Initialize and hit the Space bar to select. TAB to OK and hit Enter, and then say OK again. The array will then initialize. Once its finished, then restart the server and begin the installation process. The drivers should be native on the Server 2008 installation DVD for the controller. If not, then extract the drivers from the executable and add them to your USB key to be installed.
Although the links are out dated. I have replied, although we shall see whether I get a response or not.
The UEFI boot makes no difference to me as the array is only around 1.1GB anyways although I do have it selected over the BIOS boot.
I have tried putting the PERC H710 drivers onto a flash drive and letting Server 2008 R2 try and use them, but it pops up with an error stating that there were no new devices found.
DELL-Geoff P
990 Posts
1891
0
Posted March 28th, 2013 08:00
Use this link to download the driver, extract it to the USB key: http://downloads.dell.com/FOLDER00713584M/1/SAS-RAID_Driver_M20VR_WN32_5.2.220.64_A02.EXE
There are 2 drivers, one is for installation from inside Windows, this one is used during installation from a USB key.
Let me know.
Regards,