I have two clients who have Dell 2900's. One has PERC 5i and the other has PERC 6i. Both are running RAID with a single virtual disk.
I have added another physical disk and would like that disk to be visible to Windows Server 2003. I do NOT want to included this disk in the current RAID scheme.
In Dell Server Management (on the 2900/6i), I can see the RAID disk assigned to Connector 0. I can see the new disk is attached to Connector 1. When I look at the new physical disk (1:0:4) is says it is READY. (But, it does not show in Windows). The available Tasks for the drive are: Blink, Unblink, Assign Global Hot Spare, and Clear.
Are there some simple, easy to follow, instructions that will allow me to add this disk as a separate disk? I need to be extremely careful as this server is in production and I do not want to do anything that would disturb the existing RAID setup!!
You need to configure this drive in the RAID controller in order for it to be seen by Windows, as Windows only knows what the controller tells it is there. In OMSA, go to Storage, PERC, Information/Configuration (link at top of the page), then Create/New from the dropdown for the controller. This will show you all available drives (should only be your new one), and will ask you what RAID level you want - you can only do a RAID 0 with a single drive. This will not affect the existing RAID arrays.
I have a 2950 with PERC 5 and 4 drives in connector 0 slots 0:0:0 - 0:0:3 configured RAID 5. I need to add another drive to this RAID 5 array quickly so added the same size drive in the next slot. It shows as connector 1 slot 1:0:4 with status of Ready. However, the only options I see in the "Available Tasks" for this drive is Blink, Unblink, Assign Global Host Spare, and Clear.
How can I add this drive to my current RAID array and make it availible to Server 2003 using OMSA??
theflash1932
11 Legend
•
16255 Posts
775
1
Posted December 27th, 2010 21:00
You need to configure this drive in the RAID controller in order for it to be seen by Windows, as Windows only knows what the controller tells it is there. In OMSA, go to Storage, PERC, Information/Configuration (link at top of the page), then Create/New from the dropdown for the controller. This will show you all available drives (should only be your new one), and will ask you what RAID level you want - you can only do a RAID 0 with a single drive. This will not affect the existing RAID arrays.