Mbhalla

updated

7 years ago

M

Mbhalla

1 Rookie

•

5 Posts

0

7428

July 15th, 2019 06:00

iDRAC Not respond - PowerEdge R320

In my PowerEdge R320, when the machine starts it reports it configures memory, then initialises iDRAC then reports
Alert! iDRAC not responding. Rebooting.

It then reboots, and goes through the above again to POST screen where it says
Strike the F1 key to continue
Press F1...
iDRAC Settings:
SWC0700: iDRAC is not ready. The configuration values cannot be accessed.
Press F1 to continue. F2 for setup. F11 for boot menu.

F1 loads the windows but fans are running full speed.

Clearing the flea power and also resetting the iDRAC holding the i Button has not made any affect.

Please advise. Thank you in advance.
  • Daniel My

    12 Elder

    •

    6204 Posts

    6685

    1

    Posted July 15th, 2019 09:00

  • Mbhalla

    1 Rookie

    •

    5 Posts

    6665

    0

    Posted July 16th, 2019 05:00

    Thanks for the reply.

    We do not use iDrac - will taking out the iDrac card help resolve the issue?

  • Daniel My

    12 Elder

    •

    6204 Posts

    6649

    0

    Posted July 16th, 2019 08:00

    No, the iDRAC cannot be removed. The iDRAC is embedded. I'm not sure which component the iDRAC is embedded, it is probably the system board. The iDRAC acts as the BMC and controls fans. It is not an optional component, if it is not working properly then there will be issues like what you are experiencing.

  • Mbhalla

    1 Rookie

    •

    5 Posts

    6646

    0

    Posted July 16th, 2019 09:00

    Thank you - I will go the our data center and start with loading firmimg.d7 using SD card but as far as I think our server does not have a slot for SD Card (I am not sure though).

    What would be the next step if there is no SD Card slot on the server?

  • ikorobov

    2 Posts

    5497

    0

    Posted February 11th, 2020 14:00

    @DELL-Daniel My 

    Is that any option if we have not SD-card slot?

    May installation of iDRAC expansion card help in this case?

    Will controller take firmware file from expansion SD card slot?

  • DELL-Josh Cr

    Community Manager

    •

    9801 Posts

    •

    45350 Points

    5488

    0

    Posted February 11th, 2020 14:00

    Hi,

    You will have to replace the system board if there is no sd card.