I am trying to setup a PowerConnect 3448 to use 802.1x port authentication with a windows 2008 NPS Server, the aim is to only allow authenticated computers onto the network and to move guests onto a guest VLAN, but for now I just want to get the first part working.
I am able to authenticate a computer on the switch and the port shows as authenticated and if I look in the event logs on the NPS server it shows as full access being granted to my user account.
So everything looks ok but although the connection is authenticated I have no network access from the client, the workstation can not get an IP address and if I manually assign an address it still does not work.
I suspect its either todo with VLANs or the NPS server not sending the required RADIUS attributes to the switch but I am unable to find any specific settings for either in the manuals or on the internet.
The config is shown below, at the moment there are no entries for the dot1x users and dot1x advanced commands as there are no clients connected. I will connect a client and post the output of thoses commands after the weekend.
On arrival at work today I reconnected my client to the switch to do more testing and get the dot1x output and the client authenticated (as normal) but this time to my amazement I got network access, yet nothing has changed other than a reboot of the client.
I am going to do more testing but the dot1x output is as follows:
console# show dot1x users
Session Auth MAC Port Username Time Method Address -------- ------------------------------ -------------- ------ ----------------- e3 MYDOMAIN\myuser 00:03:21 Remote 00:1b:38:33:c4:a5 console# console# show dot1x advanced
After further testing the port authentication appears to be working ok now, in additon the guest vlan is also working fine.
The only issue I have now is handling port authentication on ports which have a small desktop switch attached, there are very few of these but I would like to be able to have a solution to the problem.
With the port authentication set to auto the first client will connect ok but no other clients can connect as the port has already been authenticated. I have looked at the "multiple hosts" function but enabling or disabling this does not appear to help. so far i have either been able to allow just one user to connect or allow all users to connect but without authenticating.
Is there a simple solution to having multiple hosts hanging off a single port?
This switch does not support "mulitple session" mode. "multiple session" mode enables only the authorized host for multiple-session access to the port. i.e. each host must authenticate.
"Multiple Host Mode" enables multiple hosts to be attached to a single port, for single-session access. Only one host must be authorized for all hosts to access the network. If the host authentication fails or an EAPOL-logoff message is received, all attached clients are denied network access. i.e. Only one host must authenticate. The question you are asking is, "can the other hosts authenticate?". I am not sure, but from your experience I would say no.
All current shipping powerconnect switches support "multiple session".
bh1633
909 Posts
925
0
Posted November 5th, 2010 08:00
Post output of "show running-config", "show dot1x users" "show dot1x advanced".