UNSOLVED

thearties

updated

7 years ago

T

thearties

1 Rookie

•

8 Posts

0

789

September 9th, 2019 18:00

Config / Version Advice for 8132f with 55xx, N20XX series

Dear All, I'm tasked to manage a set of 8132f as core switch (2 units stacked) with several 55xx, N20xx (edge switches stacked). Version on units as follow: 1) 8132f running 5.1.0.1, 2) 5548 running 4.1.0.12, 3) 2024 running 6.2.0.5, In the config, I found the following: Interface te1/0/1-2 channel-group 1 mode on Interface port-channel 1 switchport mode trunk switchport trunk native vlan 254 switchport trunk allowed vlan 3,7,9,12,254 Question: 1) Could someone advise me whether the version running are the recommended version to be running as of today. Asking coz I see some cli are not not working with current. Which version should it be running? 2) I noticed that when 'channel-group 1 mode on' is being used, it doesn't show partner info when 'show lacp port-channel 1' is run. Should it be changed to mode active instead? 3) Also, should I be seeing bandwidth > 10GB when int te1/0/1 & te2/0/1 are being used as port-channel? Appreciate your time and comments. Thank you.
  • thearties

    1 Rookie

    •

    8 Posts

    698

    0

    Posted September 9th, 2019 18:00

    Dear All,

    I'm tasked to manage a set of 8132f as core switch (2 units stacked) with several 55xx, N20xx (edge switches stacked).

    Version on units as follow:
    1) 8132f running 5.1.0.1,
    2) 5548 running 4.1.0.12,
    3) 2024 running 6.2.0.5,

    In the config, I found the following:

    Interface te1/0/1-2
    channel-group 1 mode on

    Interface port-channel 1
    switchport mode trunk
    switchport trunk native vlan 254
    switchport trunk allowed vlan 3,7,9,12,254

    Question:
    1) Could someone advise me whether the version running are the recommended version to be running as of today. Asking coz I see some cli are not not working with current. Which version should it be running?

    2) I noticed that when 'channel-group 1 mode on' is being used, it doesn't show partner info when 'show lacp port-channel 1' is run. Should it be changed to mode active instead?
    3) Also, should I be seeing bandwidth > 10GB when int te1/0/1 & te2/0/1 are being used as port-channel?

    Appreciate your time and comments.

    Thank you.

  • DELL-Josh Cr

    Community Manager

    •

    9801 Posts

    •

    45350 Points

    669

    0

    Posted September 10th, 2019 11:00

    Hi,

    Check the service tags on https://dell.com/support to look for the latest firmware versions. Active is LACP, mode on is a static port channel. If you have two 10G ports in a port channel it will depend on how you test for the bandwidth.