LordZoltan

updated

11 years ago

L

LordZoltan

13 Posts

0

287588

October 2nd, 2015 19:00

Precision M6800 (FirePro) Display corruption on 2nd screen

When I connect a second screen to my laptop, via DisplayPort-DisplayPort I get an unusable desktop.  The mouse cursor on the second screen is fine, but everything is garbled (weird blocky behaviour, and the actual desktop image is completely unintelligible).  Of I disable switchable graphics, then both screens go the same way.

I've done a boot-time diagnostics, and that completed successfully.

I also tried a diagnostic on the FirePro from the Dell Support Centre (pc doctor) application and that failed on one or two of the tests.

I am running Windows 10 x64, and have installed the Dell 'official' Intel Drivers, followed by the AMD drivers - no joy.

I have had it work on two separate occasions.  But now it doesn't work at all.

Appreciate any help.

  • LordZoltan

    13 Posts

    3358

    0

    Posted October 18th, 2015 14:00

    Hi, so after the Dell Engineer visit, my laptop is now working perfectly; both single-screen, and with the second screen attached.

    Thanks Rishi for sorting this out :)

  • DELL-Rishi

    6 Operator

    •

    2035 Posts

    3293

    0

    Posted October 2nd, 2015 22:00

    Hi LordZoltan,

    If the display projected is not clear, we can suspect an issue with the video card. When did the issue start? Does the system overheat? Is the issue seen when you try to duplicate or extend the display?

    Update the BIOS from support.dell.com - http://dell.to/1kGWIcI - enter the service tag and select drivers and downloads and run the BIOS update.

    Now, you say that the tests failed when you happened to run the pcdoctor. Could you open the application again and provide us with the exact error code. Is the system under warranty?

    Keep us updated.

  • LordZoltan

    13 Posts

    3293

    0

    Posted October 3rd, 2015 02:00

    When did the issue start? Does the system overheat? Is the issue seen when you try to duplicate or extend the display?

    The issue started after the first time I connected the second  screen.  So, the first time I did it - it worked straight  away.  It was the next day, after having disconnected it to use somewhere else, when I connected it back up, the display initially initialise.  Then, when it did, it was garbled.

    I don't believe it's overheatin - at least it's never shut down due to heat.  It runs reasonably warm, of course, because it's a bit of a 'beast', but I don't believe it's getting too hot.

    Update the BIOS from support.dell.com - http://dell.to/1kGWIcI - enter the service tag and select drivers and downloads and run the BIOS update.

    All BIOS and drivers are fully up to date.

    Now, you say that the tests failed when you happened to run the pcdoctor. Could you open the application again and provide us with the exact error code. Is the system under warranty?

    I'll try and do this when I can get in front of the laptop again.  From memory it wasn't an error vpde, under two of the DX11 tests it simply said: 'Cannot run test' and in the system error log, there was a message about the AMD driver crashing.  In fact, the driver crashes all the time.

    Yes, the system is still under warranty - it's only a year or so old.

  • LordZoltan

    13 Posts

    3293

    0

    Posted October 3rd, 2015 02:00

    For reference, please find attached a photo of the second screen.

    The amount of corruption changes each time I connect the screen - it's not consistent - but always present.

  • LordZoltan

    13 Posts

    3293

    0

    Posted October 3rd, 2015 03:00

    Sorry - I didn't do the upload of the display photo.  Please find it attached to this post.

    1 Attachment

  • DELL-Rishi

    6 Operator

    •

    2035 Posts

    3293

    0

    Posted October 4th, 2015 00:00

    Hi LordZoltan,

    Thank you for the update.

    Since you have updated the BIOS and reinstalled the drivers and the system still crashes with video driver errors, I would suspect a HW failure. Could you connect the system via a HDMI cable and test it for us?

    Since the system is under warranty, please send me the service tag of the system and your contact details through a private conversation. Or you could use Twitter - @dellcarespro - for faster communication.

    We shall setup a service call based on your warranty and your region.

    Keep us updated.

  • LordZoltan

    13 Posts

    3293

    0

    Posted October 4th, 2015 11:00

    Hi there - I'll get my service tag as soon as I can.

    I've tried HDMI connection, and it's the same.

    The problem I have is that I cannot be without this laptop - it's for business use and if I have to send it back for repair, then I cannot work.  If you could send me a replacement card for me to install myself under warranty, that would be ideal.

    Like I say, though, I shall get my service tag and PM it to you.

    Thanks

  • LordZoltan

    13 Posts

    3293

    0

    Posted October 5th, 2015 08:00

    Hi,

    I have an update on this.  Please see the following AMD threads:

    [View:Https://community.amd.com/thread/171381]

    And

    [View:Https://community.amd.com/message/2666937]

    Both users have the same laptop as me.

    The first of these is from March this year, saying that if he/she used any version newer than 14.9, thy had display corruption.

    The second is much more recent, and relates to Windows 10, the same as me.

    There is no 14.9 release for Windows 10 that I can find.  It appears that AMD and Dell need to work together to sort this problem out - it's not faulty hardware, but faulty software (a surprise from AMD there...).

    In the meantime, it's impossible to use multiple monitors with this workstations grade laptop.

    I am decidedly annoyed at this - and am dismayed that Dell are promoting my Laptop as 'Windows 10 ready' when it clearly is not.

  • DELL-Rishi

    6 Operator

    •

    2035 Posts

    3323

    0

    Posted October 6th, 2015 22:00

    Hi LordZoltan,

    Thank you for the update.

    Q: Did the system work fine before you upgraded the OS to W10, while the system was on W8.1?

    Keep us updated.

  • LordZoltan

    13 Posts

    3323

    0

    Posted October 7th, 2015 00:00

    Well, I never saw this problem, certainly, when running 8.1.

    But...  I also never tried connecting a second screen to the laptop prior to having Windows 10.

    I can force it to show the corruption on the main laptop screen by disabling 'switchable graphics' in the BIOS.  The corruption doesn't occur, though, till windows starts - implying it is a driver problem.

    What I will say is that I had disabled most of the AMD  driver software from running in Win8.1, because it regularly crashed - out of the box, that is.

    Had I not already been aware of just how rubbish AMDs drivers are, I would have sent it back.  Perhaps I should have - I wish I'd chosen the Nvidia build now, because this is a farce.  To see other people with the problem makes me think someone has failed to do QA something.

    The question is who?  Dell or AMD?

    So this is what I want - I'd like a new Nvidia version of the laptop, with the rest of the hardware exactly the same, sent to my address.  I'll image this one, and restore it on the new one.  And you can take this defective one away and burn it.  Or sell it on the outlet store.

    Can you make this happen, please?