
UNSOLVED
Latitude D630 Semi-dead Video
My D630 video seems to have died.At boot it will flash the Dell logo and then go blank, it appears the back light is turning off. I can see the faint intel and energy star logos after boot and eventually see that the laptop appears to get into windows.I can see the screen change colors if i use the display boot test, extremely dull, the backlight isn't on, i can see a small change in the screen color but not proper display (boot with d held). I get no error codes out of caps/num/scroll if I boot with power + fn key, just the caps flashing indicating no error.
An external monitor appears to work just fine.
I replaced the inverter and that seemed like it was going to do the trick. The laptop ran for a few hours and it seemed good. Power cycled it a few more times and now I'm back to where it was before. Went back and forth between the new and old inverter and both give the same symptom.
Any help would be appreciated.
Responses (3)
Solutions (0)
Hold the D key through powerup - it should initiate a color cycling on the display panel. If that looks OK, the display panel is OK. If that's the case, does the system have an nVidia video chip? If it does, these are well known for faulty engineering and they often fail in unpredictable ways (that is, they can and do fail such that the internal display is faulty while that on an external screen is OK.
If the display panel is OK and the chip is nVidia, the mainboard needs to be replaced. If you decide to make that repair, you're better off swapping in an Intel-video board (you'll need a new heatsink assembly). All of the nVidia chips are faulty and a replacement will fail in the future.
It could be the LCD wire. I've had that in the past, the wire can wear or tear near the right hinge. Easily fixed by replacing the wire (make sure to buy the correct model, 1280x800 and 1440x900 LCDs having each a different wire). Failing that, search for a 2nd hand complete LCD set (complete with cables) on the Net...
The nVidia models are well known for the inevitable GPU failures. This was the subject of some action against nVidia.
However, not all is lost when the GPU fails. It can be fixed. You can dismantle the laptop to extract the raw motherboard (use the online Service manual for assistance). Remove all stickers, even the black ones for WWAN and Wifi. If you can (or have some), sprinkle reflow liquid around the GPU. A mixture of 90% solvant with 10% violin bow resin will do too.
Now the fun part: pre-heat your oven to 200°C and place the motherboard in it for about 10mins. Then switch off the oven, open the door and let the motherboard cool down.
This will repair the GPU problem.

laserman778
1 Rookie
•
511 Posts
287
0
Posted January 27th, 2015 15:00
If the external monitor works fine, you may need to replace the LCD on the laptop itself.