
UNSOLVED
Closed
S
stiflersmom
5 Posts
0
3167
March 6th, 2008 03:00
crackling in speakers
Hello I resently purchased a used laptop inspirion E1505 from a private party. There seems to be a crackling sound comming out of speakers when I play music. Its not continuos but more than Id like. Any advise would be greatly appriciated. Thank You.
Darin
Responses (1)
Solutions (0)

Jim Coates
6 Operator
•
13582 Posts
99
0
Posted March 6th, 2008 10:00
If you reply please mention whether you have XP or Vista. There are a lot of noises that are caused just by running Vista in conjunction with other software. For example, disabling the wireless network card will stop a skipping audio. (Fn + F2 will disable the it.)
Try unplugging the power cord and run on battery power.
Try downloading and installing a new audio driver from this site.
E1505 XP
E1505 Vista
Click on the + sign next to 'Audio Drivers'. If there is more than one driver listed, your audio driver will be the one named Sigmatel. Download it but before installing it go to the "Add/Remove Programs" in the Control Panel and remove the current Sigmatel if it is there in the list of programs and restart the computer.
Check to see if you have firmware revision DE07 for a TSST TS-L462C 24x slim combo Cd rom/burner. The firmware is defective and causes noises in all audio, not just when using the drive. Open Audio Properties (right click on the volume icon on the taskbar and click 'adjust audio properties', or go through the Control Panel/Sounds & Audio Devices Properties). Select the Hardware tab. Look for DVD/CDROM in the device column. The name of the drive should be there.
Check for PIO mode.
1. Go into the 'Device Manager' (in XP the path is: Start>Control Panel>System>Hardware>Device Manager).
2. Click the + sign next to 'IDE ATA/ATAPI controllers'.
3. Right click on 'Primary IDE Channel'.
4. Select 'Properties'.
5. Select the 'Advanced Settings' tab.
6. Check that the 'Current Transfer Mode' says Ultra DMA. If it says PIO then use the 'Transfer Mode' dropdown box to select for 'DMA if available'. If you can't make the change in the dropdown box then it must be done in the Registry. This site has a method and an extensive article on this subject: http://winhlp.com/node/10
7. Click 'Ok' to save your changes, or 'Cancel' to exit the Properties if you made no changes.
8. If the problem seems related to the optical drive (CD/DVD), right click on the 'Secondary IDE Channel' and repeat steps 4 through 7.
This tip is from to bacillus, Anne in Pennsylvannia, XPS Crazy & others
Jim