UNSOLVED

BPtech4u

updated

17 years ago

B

BPtech4u

12 Posts

0

57514

August 25th, 2009 09:00

Trying to restore optiplex gx520 to original factory using restore CD

I have a few GX520 I want to totally restore windows. When I boot from the restore CD it comes up to the blue screen with white letters asking to press enter to install windows or press R for recover console or F3 to exit. But at this point my USB Keyboard light goes out and I can not hit enter key and keyboard quits working?? Ive tried several pcs but same issue. I think these came preinstalled windows. but I have the origingal resotre CDs. Ive tried booting to F12 and selecting boot from CD/DVD that does not work either It stops at the same screen with no keyboard function? I tried the Ctl F11 to see if it had a partition as per the dell website but that comes to the same screen and no keyboard. Thanks

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    855

    0

    Posted August 25th, 2009 09:00

    Have you tried the CMOS Jumper to restore the Bios Setup?
    * Power the PC off
    * Open the case cover
    * Move the RTCRST (Clear CMOS) jumper from pins 1/2 and place it on pins 2/3
    * Press the PC power button
    * Move the jumper back to pins 1/2
    * Replace the cover and power the PC on


    DELL-Chris M (old account)

    #IWork4Dell

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    855

    0

    Posted August 25th, 2009 09:00

    Did you try both banks of USB ports on the rear of the PC?


    DELL-Chris M (old account)

    #IWork4Dell

  • BPtech4u

    12 Posts

    855

    0

    Posted August 25th, 2009 09:00

    No I have not, I will try the jumper.

  • BPtech4u

    12 Posts

    855

    0

    Posted August 25th, 2009 09:00

    It has two USB ports below the Network connection and 4 USB ports next to that and 2 in front. Ive tried the keyboard in all of them. but keyboard light goes out just as the install window comes on.

  • BPtech4u

    12 Posts

    855

    0

    Posted August 25th, 2009 19:00

    I located the RTCRST, I have only 2 pins on the board and they do not have any jumper on them? any suggestions from here

  • BPtech4u

    12 Posts

    855

    0

    Posted August 26th, 2009 10:00

    I have found out I have the Small Form Factor GX520 here is the link for the inside view and the RTCRST pins. I took the battery out and replaced? updated bios to A11 still no usb keyboard when the windows install starts

    While looking around I found somethig called the DSS?? I do not have a Driver Utilities CD. All that came with these PCs was the restore CD. Is the DSS utility on that cd? Is this the reson the usb keyboard stops working because of this DSS utility needs to be running? Thanks

     <ADMIN NOTE: Broken link has been removed from this post by Dell>

  • BPtech4u

    12 Posts

    855

    0

    Posted August 26th, 2009 21:00

    I seem to have fixed the probelm and not sure what it was. I looked at the bios settings on another pc that worked. Removed the USB device from the boot seq. Then switched keyboards and mouse and booted from restore cd fine and was able to use the usb keyboard.  Thanks!