
UNSOLVED
CV
Christos Vlacho
5 Posts
0
27085
December 22nd, 2013 21:00
T3610 - no detection of 2nd HDD after RAID 1 removal
I recently purchased the new Precision T3610 with two 500GB HDDs.
The disks were configured to operate in RAID 1 configuration.
As I do not need the RAID configuration I removed it by accessing the Intel RAID utility (Ctrl+I) and setting both disks to Non-RAID.
After that, both disks are properly identified in both BIOS and Device Manager of Windows 7.
But the 2nd HDD cannot be seen on My Computer. I need to format it in order to use it as simple storage drive.
Maybe should I just turn off the RAID and just use the AHCI option in the SATA Operation tab ? (windows reinstallation is mandatory after that ?)
I need also to replace the 1st (bootable) drive with an SSD. Will there be any problems with that ?
Responses (4)
Solutions (0)
Christos Vlacho
5 Posts
396
0
Posted December 23rd, 2013 19:00
Thank you so much John !
The 2nd HDD is now properly identified, formatted and labeled.
Let's hope that I will not experience any problems upgrading the 1st (boot) HDD to a new SSD. Should I need any additional drivers or BIOS Settings ?
DELL-John C
7 Practitioner
•
353 Posts
396
0
Posted December 24th, 2013 07:00
Hi Christos,
Not a problem at all, glad I could help.
If you are installing an SSD, you won't need any additional drivers or need to change any BIOS settings, however you will need to reinstall Windows 7 or try to migrate your Windows 7 installation. This link shows you how to do so: http://www.howtogeek.com/97242/how-to-migrate-windows-7-to-a-solid-state-drive/
If you need a list of drivers for drivers for Windows 7 for your system, please let me know!
Christos Vlacho
5 Posts
396
0
Posted February 18th, 2014 21:00
The problem now is that the PC gets stuck in the Dell logo boot screen for approximately 4min.
After I replaced the primary HDD to another SSD, i disabled the RAID configuration and turn into AHCI.
That is all I changed and now I get that super-slow bootup time. Rather than that, the SSD performance in Windows is exceptional.Also, during bootup i get the 1,2 leds on, meaning possible system board failure. Is this related ?
What is wrong with the bootup time ?

DELL-John C
7 Practitioner
•
353 Posts
396
0
Posted December 23rd, 2013 05:00
Hi Christos,
You'll find the second HDD in the Disk Management properties in Windows 7. To do this, go to the Windows Start Menu and right-click "Computer" then select "Manage". Here, expand Storage and select Disk Management.
Find the 2nd HDD and right click on this - here, you can select Format and follow the on-screen instructions. After the drive is formatted, you can then assign a drive letter by right-clicking the drive and selecting "Change Drive Letter and Paths".
If you choose to replace the 1st HDD with an SSD, you will need to reinstall Windows 7. Other than that, there should be no issues at all.