
UNSOLVED
DM
David Manvell
14 Posts
0
11547
December 25th, 2007 03:00
Precision 2nd SCSI drive issues.
I have a Precision 670 Dell computer that is running Windows XP 64. The Dell has a Seagate ST3146854LW 136GB SCSI drive in it. The system has been running fine although I am running out of disk space and will also be moving over to Windows Vista x64 Ultimate shortly.
I purchased a new (From Seagate) ST3300655LW 300GB SCSI hard drive and added it to my system. The 136GB original drive is SCSI ID 0 and the new 300GB drive is SCSI ID 1. The new drive is the exact same line of drive as my original one, it's just a larger version.
My system boots up fine and Disk Management sees the new drive. I created a single partition the same size as the original drive that came with my computer (136GB).
The partition formats fine from within Disk Management. Formated NTFS, Default Allocation Unit size. Not using quick format and not using compression.
Once the drive is formatted I am able to copy files to it but only a few ones. Any attempt to copy lots of files results in the drive hanging and locking up the computer.
No problems seem to be occuring with the old drive.
Suggestions?
Responses (5)
Solutions (0)
David Manvell
14 Posts
472
0
Posted December 27th, 2007 19:00
According to the documentaion, neither drive supports any internal termination at all so the only termination present is the one on the controller side and on the end of the ribbon cable. Both drives (original and new) are in between the two terminations.David Manvell
14 Posts
472
0
Posted December 28th, 2007 01:00
Yes to both of those. All the parameters for both drives are the same according to the scsi utilities. And tried several cable connectors as well as reversing the drives.:( getting to the point where i am feeling the drive is bad.

David Manvell
14 Posts
472
0
Posted December 25th, 2007 04:00