
UNSOLVED
P
pharmaceutika
8 Posts
0
2559
July 26th, 2007 02:00
Is the XPS 400 the same as the D9200?
Stripped down that is... Is the M/B, PSU the same?
Responses (4)
Solutions (0)
pharmaceutika
8 Posts
217
0
Posted July 26th, 2007 04:00
How is the M/B "better"? I know it can take PC6700 Ram but that's about it. I'm really trying to decide if I'm getting another Dell (mid to high end) or try to build a PC myself. I must say Dell really charges a big premium for upgrading RAM, CPU, GPU, basically everything that can be bought for half the cost.ManyDimensions
1318 Posts
217
0
Posted July 26th, 2007 15:00
I just posted this the other day:I have both an XPS 400 complete system and a XPS 410 motherboard and case, so I did a visual comparison....Here are the key differences that I have observed.Differences:Rear case port connectors or REAR I/O ports. The 400 and 410 have different spacing and different options. Yes, they are uniquely different and do require the backplane for the specific model. No,the backplane is not riveted, nor glued, nor anything else.The backplane an integral part which is the rear section of the case that is riveted into place. The 9100, and 9150/400 use the same configuration. The 9200/410 does not, so the case backplane is completely different. There is a glued piece to the outside of the case but it is just for port identification purposes and does not cover up anything. The 400 case will need to be cut to accept the rear ports on the 410 mobo.The 400 front case panel I/O ribbon cable seats neatly into the 410 front case panel connector. I don't know for certain if the pin out is the same but the cable fits properly into both boards. The difference I noticed was a two wire cable (black+red) from the front case I/O panel to 410 mobo which the 400 does not have. This may be a speaker wire or a significant difference. The front I/O boards attached to the cases also appear slightly different.The fan connector for the lower case fan (called rear fan) on the 400 is a 4 pin mini connector. The lower case fan (called rear fan) connector on the 410 is a larger 5 pin just like the one for the CPU.So the 400 fan will need to be replaced or made to work with the 410 mobo.The flex-bay connector on the 400 has a mini 10 pin USB connector. The 410 has a 9 pin standard sized USB connector.DATA I/O Observations:The 400 mobo has one EIDE ribbon connector and 4 SATA connectors. The 410 has 6 SATA connectors and NO EIDE ribbon connector.The ribbon cable connectors for the floppy and auxiliary PS2/COMM port are in the same location and pinned the same for both the 400 and 410 mobo.Motherboard Mounting holes:Both the 400 and 410 appear to have the same mounting hole configuration. I placed the 410 over the existing board for a visual. I don't see any difference at all as far as mounting to the case..

DELL-Donald K
2 Intern
•
3969 Posts
217
0
Posted July 26th, 2007 03:00
DELL-Donald K
#IWork4Dell