slaine666

updated

11 years ago

S

slaine666

1 Rookie

•

7 Posts

0

13726

August 19th, 2015 05:00

GX620 sff alert ! fan failure

Hi,

I have read many topics about GX620 sff and its thermal/cooling issues.

But I didn’t find exactly the same problem that the one I have.

During bios boot I have the following message: alert! cpu fan failure

The cpu’s fan is spinning but at very low speed and it never increase despite the temperature.

I read somewhere on the forum that gx620 sff has no CPU t° sensor, seems a bit weird…

In the event report, we could see fan failure: out of range

Someone has already seen this issue ?

My plan for this computer is to upgrade cpu, ram and heatsink

My GX620 has a P4 2.8ghz with 2 go of ram, a HD 80gig and VGA card on PCI port

BR

Nicolas

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    1228

    0

    Posted August 19th, 2015 12:00

    The system probably doesn't have a temp sensor that reports CPU temps to Windows so you can't see them. But, Dell CPU fans typically have a sensor that allows BIOS to control fan speed based on CPU temps.

    If that sensor fails, you'll get the CPU fan failure alert. Reboot and press F12 before Windows starts to load. Go to the Utilities partition and run the fan diagnostics.

    Assuming the fan fails, reboot and press F2 to open BIOS setup. Copy down all the current settings. Then power off, unplug and press/hold power button for ~15 sec. Open the case and carefully reseat the CPU fan connector to the motherboard. Then remove motherboard battery and press/hold power button for ~30 sec which should clear the fan error. Reinstall the battery and close case.

    If you get the fan failure error at next boot, it's likely the fan's sensor failed and you'll have to replace the fan. If you install a non-Dell fan (which won't have that sensor), you'll still get a fan failure error at every boot.

    NOTE: If you get any other error messages after clearing BIOS, reboot, press F2 and open BIOS setup. Make sure all the settings match what you wrote down and save any changes before exiting setup.

  • slaine666

    1 Rookie

    •

    7 Posts

    1228

    0

    Posted August 19th, 2015 14:00

    Unfortunetly i cannot boot to utility partition 'cause it's not available

    So i performed your instruction and i still have the message so the sensor of the fan should be down

    I will try to find another one

    Thank you for your advise

  • slaine666

    1 Rookie

    •

    7 Posts

    1228

    0

    Posted August 21st, 2015 01:00

    I try to replace this fan with an auto regulated fan (with an integrated sensor),  the one I used has only 3 wires (it’s a dell precision 380’s fan case)

    And i still have the message, should it has worked?

    I’m not sur to understand what data is missing to the motherboard to understand that the fan is working correctly, is it the fan’s rpm pulse or something else?

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    1228

    0

    Posted August 21st, 2015 10:00

    Dell fans are typically specific for one or a few models. So it might not be surprising that the one you installed still gives the fan failure error, especially if it has a different number of connectors than the original.

    Look around the net for the right fan for this specific PC model. Probably less than 10 bucks...