Drodman91

updated

15 years ago

D

Drodman91

10 Posts

0

7558

February 17th, 2012 19:00

Dell E510- No power, no blinking light

Hi All,

A few months ago, I inquired about my Dell E510 which would constantly blink for days to weeks before it would turn on at all.  Recently, it stopped blinking and powering on in general.  I figured it was surely the power supply that needed to be replaced, so I bought a new one.  I just installed it, re-checked everything, and it doesn't work.  Any ideas?

Thanks.

  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    328

    1

    Posted February 18th, 2012 14:00

    That is a small "flea power" voltage from the power supply.  It does not guarantee the power supply is good. If you can jumper the GREEN to BLACK on the 24 pin power connector and the power supply does not turn on it says it's no good.  On the other hand if you jumper it and it turns on, it doesn't say the power supply is good but it says the problem is either the motherboard, front panel power switch or interconnecting cable.

    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application
  • rdunnill

    8 Professor

    •

    8811 Posts

    •

    35254 Points

    328

    0

    Posted February 17th, 2012 20:00

    You might have a mainboard problem.

  • fireberd

    11 Legend

    •

    33399 Posts

    •

    112848 Points

    328

    0

    Posted February 18th, 2012 03:00

    Did you connect both connections to the motherboard?  The 24 pin main power connector and the 4 pin Molex for CPU power.  We have seen a couple of posts where users replaced power supplies and forgot the 4 Pin Molex CPU power connector.  

    If that is OK, disconnect the 24 pin power connector and then jumper the GREEN wire to BLACK wire and see if the power supply starts up.  If not, the new supply is dead.

    Inspiron 16 5630 Laptop and WD22TB4 Docking Station
    Self-built desktop for recording studio application
  • Drodman91

    10 Posts

    328

    0

    Posted February 18th, 2012 09:00

    Okay, so I took the old supply and tried shorting it, then connecting it.  Originally the old supply lit up the green light on the motherboard. After shorting it, it no longer lit up.  After installing in the new one once again, the green light on the motherboard lit up once again.  I probably should have added that before.  It still wont start

  • tmaresh

    1 Message

    328

    0

    Posted July 1st, 2012 22:00

    I had the same/similar problem with my E510, I turned it off while I went on vacation and when I tried turning it on it appeared dead. I opened it up and jumped the green/black wires from the power supply to the mother board and it fired up. If I removed the paper it would run but if it shut down, I'd have to do the paper clip thing again. I replaced the power supply with a stand ATX PSU with 380 watts. I connected all the wires and viola. Switch works on and off. Think its fixed...