UNSOLVED

fldq

updated

19 years ago

F

fldq

16 Posts

0

6782

August 19th, 2007 05:00

9150 inside noise caused by spinning

From scratch on, (1.5 y) this dimension 9150 makes a lot of disturbing noise while using the DVD. The dvd spinning is causing an alarming vibration.
 
While holding the case very very firmly together, the vibrating is much less.
 
What could I do?
I have checked that there is no cable loose but I have no further clue...
 
Thanks for any insights
  • ManyDimensions

    1318 Posts

    194

    0

    Posted August 19th, 2007 10:00

    fldq
     
    There have been a large number of posts concerning the same issue.
     
    To lessen vibration, some people have used anything from tooth picks as wedges, to foam rubber but none of the home made remedies stopped the problem.
     
    Case side vibration can be reduced by slightly bending the Y shaped latches to secure the side panel.
     
    The best solution is to replace the DVD with a higher quality unit if you find the noise just too annoying but still need the DVD drive.
     
     Otherwise, unplug the power connector to the drive and pretend it is broken. (not really)
     
     


    Message Edited by ManyDimensions on 08-19-2007 06:10 AM
  • Silent157

    38 Posts

    194

    0

    Posted August 19th, 2007 18:00

    I was going to say maybe it's a slightly loose screw, but I think DELLs use clips and whatnot to hold drives. If so, maybe you can put small pieces of bounty paper towel where the clips and the case make contact. The drive in that system just may be causing a lot of vibration and sharing it with the case. The one idea is to try to soften the contact areas like I mentioned above. Another would be, like someone else said...to replace the DVD drive with another that should cause a lot less noise.
  • innocent12

    1 Rookie

    •

    61 Posts

    •

    22 Points

    194

    0

    Posted October 15th, 2007 13:00

    Try following:
     
    1. Fit self-adhesive neoprene pads under the PC case if you stand it on a wooden floor or desktop. (Dell omiited them to save a cent or two.)
     
    2. Pack BlueTac around the shoulder screws and in to the mounting slots that secure the DVD Drive. 
     
    Worked for me.