UNSOLVED

stingray355

updated

21 years ago

0

8345

September 5th, 2005 00:00

8300 won't boot

I have an 8300  XP Pro, 1 gig ram, and put it on standby and it was hooked to a UPS came back in a couple of days and it won't boot up. I get nothing on the screen. I have yellow yellow green green lights. won't boot with cd either. Is there some procedure to return to the status I had before going to standby? Did my UPS run out of juice and crash my system? Is it just coincidence that this happened after going to standby? Help! Thanks
  • ejn63

    11 Legend

    •

    87469 Posts

    •

    321256 Points

    77

    0

    Posted September 5th, 2005 00:00

    Reseat the memory modules. If that doesn't cure the problem, remove them one at a time until you find the faulty one.
  • 77

    0

    Posted September 5th, 2005 19:00

    Funny - sounds like I'm having the exact same problem.  I can't remember exactly, but I think I did change the standby settings the last time I used my computer.  Now, whenever it starts to boot up, it stops after a second or two and the diagnostic lights on back are A+B yellow and C+D green.
     
    I read the manual part which says it's a memory module problem.  However, I took them each out and tried to boot, but to no avail.  I also tried switching one in place of the other, but that didn't help.
     
    This is really getting frustrating!!!  And I'm out of the warranty by about a month!!
  • 77

    0

    Posted September 5th, 2005 21:00

    Thanks  I removed 2 memory sticks and it booted up fine. I then was about to buy another 512 to replace the ones removed and decided to try the old ones again before I went out to the computer store. Booted fine and the full 1 gig ram shows up. I think the standby thing was a coincidence in my case. I thank you for the assistance and wish the other person good luck with their 8300. I like the Dell computers and this is the first problem I have had.