is there a possibility to change the Netmask of an EQL after it has been set up?
In the GUI i have only found that place where to change the Group IP and the Place where I can Manage the IP and Netmasks of the Interaces. Same for the CLI.
Is the Netmask of the Group IP just the same as the one of the Interfaces, as long as they aren't reserved for Management?
I've had this on hand myself and I do have one remark;
The management IP takes the subnet mask of the first interface, hence eth0. The procedure would be "simply" to start changing ip's on eth1 and further and lastly eth0.
It's documented in "Changing PeerStorage member or group IP addresses_a02.pdf" which I got from EQL support which provides a step by step guide for changing ip's.
Cosus-MSCH
5 Posts
2301
0
Posted May 28th, 2012 08:00
Thanks for the quick answer/confirmation Don
regards
Mathias