Pro Max 16 MC16250, fan noise regression, 60% fan floor on AC power (Linux)
System Configuration:
Model: Dell Pro Max 16 MC16250
BIOS Version: 1.9.0 and 1.7.0
OS: Ubuntu 24.04 / 25.04 (OEM Kernel 6.14.0)
Power Source: Original 130W USB-C and 65W USB-C (Behavior is identical on both)
The Issue: The Embedded Controller (EC) triggers a mandatory "Hard Floor" fan speed of approximately 60% the moment any AC power is detected. This happens even when the system is under zero load and temperatures are well within "Silent" range.
Observed Behavior:
On Battery: The system is perfectly silent. CPU temperatures hover at 40°C, and fans stay at 0 RPM.
On AC Power: Within seconds of plugging in (130W or 65W), the fans ramp up to 60% and stay there indefinitely, even if the CPU remains at 40°C.
Hysteresis: Unplugging the AC power results in the fans stopping almost immediately, proving the trigger is the Power State, not the Thermal State.
Steps Taken to Resolve (All Failed):
BIOS Settings: Thermal Management set to "Quiet." Intel SpeedStep/SpeedShift toggled Off. Battery Charge Cfg set to "Custom" (stopped at 80%) to reduce charging heat.
Dell Command | Configure (cctk): Successfully set --ThermalManagement=Quiet and --PrimaryBattChargeCfg=Custom. However, cctk --search and other low-level queries return Segmentation Faults, indicating SMM write-protection is blocking OS-level thermal control.
Ubuntu Power Management: Set to "Power Saver" mode. CPU frequency successfully capped at 800MHz. Energy Performance Preference (EPP) set to power. Fan speed remained at 60%.
Kernel Parameters: Tested acpi_enforce_resources=lax and dell_smm_hwmon.force=1. No PWM control files were exposed in /sys/class/hwmon/, confirming the EC is operating in fully autonomous mode and ignoring the OS thermal requests.
Thermal Zones: All thermal_zone readings (0–9) show temperatures between 20°C and 47°C. There is no "hotspot" justifying 60% fan speed.
Conclusion/Request: The current EC firmware for the MC16250 is too aggressive. It appears to be using a "failsafe" cooling profile for AC power that ignores the actual component temperatures.
Request to Engineering: Please release a BIOS update that allows the "Quiet" thermal profile to maintain 0 RPM fans on AC power when CPU/GPU temperatures are below 50°C.
Please go to Drivers & Downloads, make sure the correct operating system is selected so the Linux-compatible updates are displayed, and install the latest BIOS version.
After the BIOS update is complete, restart your device and check whether the fan behavior reported in this thread has improved.
I'll buy never again Dell. Their design team seems to be tone-deaf. The fans are screaming like a jet taking off, and the laptop isn't even doing anything!
@SurfGaia Just wait until the coil whine kicks in… We’re locked into a leasing contract for this “beauty” until 2030. At this rate, I’m just hoping my hearing gives up before I have to keep listening to that nonstop high‑pitched noise.
DELL-Nat M
Community Manager
•
3803 Posts
•
21463 Points
6
0
Posted July 14th, 2026 16:16
Hi all,
A new BIOS update is available as of today.
Please go to Drivers & Downloads, make sure the correct operating system is selected so the Linux-compatible updates are displayed, and install the latest BIOS version.
After the BIOS update is complete, restart your device and check whether the fan behavior reported in this thread has improved.
Please let us know your results after testing.
#IWork4Dell