UNSOLVED

Sanjit1

updated

16 years ago

S

Sanjit1

45 Posts

0

3134

September 15th, 2010 07:00

the management port at SP-A is running in half duplex mode

Got a warning at Navisphere that the Clarrion management port at SP-A is running in half duplex mode. Is it anything seroius?

  • Parks2

    116 Posts

    1357

    0

    Posted September 15th, 2010 07:00

    No .. What kind of array and what is the code level

  • Parks2

    116 Posts

    1357

    3

    Posted September 15th, 2010 07:00

    See primus

    ...

    The following is a Primus(R) eServer solution:

    ID: emc225054
    Domain: EMC1
    Solution Class: 3.X Compatibility

    Goal       Why do Management Port Settings 'Requested speed setting' revert to auto after management module reseated?

    Fact       Product: CLARiiON CX4 series

    Fact       Product: CLARiiON CX3 series

    Fact       EMC Firmware: FLARE Release 29

    Fact       EMC Firmware: FLARE Release 28

    Fact       EMC Firmware: FLARE Release 26

    Symptom    Management Port Settings "Requested speed setting" revert to auto.

    Change     Customer modified the management port setting "requested speed setting" to 100 Mps/full duplex

    Change     Customer removed and inserted the Management Module.

    Change     Customer modified the management port setting "Requested speed setting" to 100 Mps/half duplex.

    Fix        This is working as designed. Navisphere Help recommends leaving Management Port Settings set to ''auto.''

    According to the Navisphere Help file:  "Requested Settings Sets the speed for the management ports. The default setting is Auto . We strongly recommend that you contact your service provider before changing these settings."

    Note       Customer verified Management Port Settings from naviseccli -h <IP address> networkadmin -get -all.

    Note      

    Refer to solutions:

  • Sanjit1

    45 Posts

    1357

    0

    Posted September 15th, 2010 10:00

    Thank you Parks

  • Sanjit1

    45 Posts

    1357

    0

    Posted September 16th, 2010 01:00

    Array : Clarrion CX4-480

    Flare Operating Environment : 04.28.000.5.708

  • Rezgui

    22 Posts

    1357

    0

    Posted February 24th, 2016 06:00

    Hi, How can you change it to Full duplex all articles I can find are about CX4 and solutions are not compatible with VNX ?

  • ZaphodB

    195 Posts

    1357

    1

    Posted February 24th, 2016 09:00

    In Unisphere, select network settings from the settings icon at the top (near right side...).

    Then set each SP from the link on the right side.

  • kelleg

    6 Operator

    •

    4537 Posts

    1357

    1

    Posted February 25th, 2016 14:00

    Just set the switch port to auto/auto and the SP port to Auto - it will negotiate to the correct speed and duplex

    glen