I recently snagged an EVGA GeForce RTX 3090 FTW3 Ultra Gaming, 24GB GDDR6X and tried to stuff it in the Aurora R8 case.
If you remove the front case intake fan it fits length wise. However, the width of the card prevents the power supply from fully closing the case. The little triangle piece on the power supply that has the cord holder gets in the way.
I could probably cut the metal piece off but wonder if there is a more elegant way of removing.
I've circled in the 2nd picture the part that is preventing case closure.
I like Dell630i's way of cutting off the triangular steel support of the swing arm. If I were the OP, I would also install a (ultra-compact) GPU brace support though. Without the factory plastic hinge, now that one poor PCI-e slot on the mobo is bearing the weight of the entire EVGA 3090.
Seeing that someone has done it already gave me the courage to cut that triangle piece off. The bottom half of the swinging contraption is weakened without the triangle so I need to be a little more careful when closing the case now. Here are the pics
Triangle is gone
WIth side panel on
Since the front intake fan is removed from inside inside the case, I have a slim noctua nf-a12 in the case grill as intake. It kind of reduces the aesthetic of the case front though as you can see the fans cream coloring. But you can also see the RGB glow from the graphics card which adds some coolness factor.
Nice! Just a heads up the the metal vents on the bottom of the chassis where the noctua fan is covering don't go anywhere ( so the noctua fan is pulling air from the other side of the case where the 2.5" hdd caddy and unused cables are placed. The plastic legend cases have outside exhausts but the R8 doesn't. If you wanted you could open up thr bottom of the case so your noctua is pulling outside case air to cool the gpu instead of recirculating inside air.
Yo man great job. I want to upgrade my Aurora R7 V.Card to RTX 3080 ti from Asus. It's length 318.5 mm. Will it fit into this case? And if you remove that front fan doesn't it kill the hardware inside?
Look at my result bro ... a rx 6700 xt into my r8 ... i had to cut the corner of the frame and the power supply corner... exchanged the front fan for 2 little one 4 pins. Pretty satisfied of my result
AuroraHasManyFans
1 Rookie
•
118 Posts
7348
1
Posted November 25th, 2020 19:00
I like Dell630i's way of cutting off the triangular steel support of the swing arm. If I were the OP, I would also install a (ultra-compact) GPU brace support though. Without the factory plastic hinge, now that one poor PCI-e slot on the mobo is bearing the weight of the entire EVGA 3090.