So I just added a 2nd intake fan using and using a SATA Powered PWM Splitter. When I booted my R16 up I get a Fan error message and my fans start running full blast. I don't know what next step to take any help would be apricated.
Fans need to be connected to the Mobo fan headers or a USB controller to be monitored/controlled. If only connected to power with a splitter, they're only gonna run full speed. You can buy a 4-pin fan splitter for the board header or only connect the second fan to the 'dumb' power splitter. Usually there's more than one fan header on decent desktop boards or they add a fan controller box from the factory - most prebuilts can accomidate multiple fans but I guess I wouldn't be shocked if they only have one board header for yours given Dell often uses proprietary boards with missing standard features.
Not sure what "SATA Powered PWM Splitter" is, because you don't modulate fan control with a SATA powered fan. You can use a PWM Y-splitter cable to connect a second fan, making sure your Dell OEM fan is connected to the 4-pin side of the PWM Y-splitter cable. No SATA power required.
@ProfessorW00d I think it's a SATA powered fan controller as there's likely no 4 PIN Fan header available on the motherboard to connect an extra fan.
If that is what it is, a Y-splitter is the best option as you already pointed out. I know some fans come with their own controller as they need it for a reason, but a regular fan does not need a special fan controller.
you need this type of connector. You plug it into the mobo fan header, then plug both fans into the splitter and plug the data adapter into the hard drive sata slot at the bottom and it’ll work fine, it’s what I used.
I have no top fans in my R16. If you add a fan to the open fan Pin header it shows an error on boot. Don't see why you cant use the unused fan pin headers for extra fans.
Tried this fan from ebay. Its supposed to be Genuine Dell. It had the correct bracket snaps right into case with no tools. once I plug it into the fan header and restarted, the error shows.
Have another fan question. I see on Ebay the 240 duel fan with Alien affects. Can that just be pluged in and replace the 120 or does some setting have to be changed so the board knows your using the top two fans for the cooler?
Hi. I'm going to do the same. Just received the fan I bought from ebay today. The fan has 2 part numbers on it: 0X176F and 0HTKP6. It does snap right on top of the bottom intake fan.
The only difference is that the current on the AVC is 1.02A lower than the 1.20A on the original Foxconn. Wondering if it would work ok?
I'm going to use the cable which is coming from Amazon. I bought these by following a thread on Reddit.
It will work if you use the Sata cable your showing. I added the fan using the cable and it works perfect. I using the foxconn but you can use any fan with that cable setup.
Mike1788
1 Rookie
•
62 Posts
0
0
Posted May 6th, 2024 03:00
Fans need to be connected to the Mobo fan headers or a USB controller to be monitored/controlled. If only connected to power with a splitter, they're only gonna run full speed. You can buy a 4-pin fan splitter for the board header or only connect the second fan to the 'dumb' power splitter. Usually there's more than one fan header on decent desktop boards or they add a fan controller box from the factory - most prebuilts can accomidate multiple fans but I guess I wouldn't be shocked if they only have one board header for yours given Dell often uses proprietary boards with missing standard features.