AIX bosboot routine prefers to use hdiskpower11 but as you can see in the bootlist, the boot device is hdisk17.
I tried running the pprootdev off command but it returned this error:-
/[root]# pprootdev fix
hdiskpower0: Not yet configured as PowerPath device (Available State)
/[root]#
/[root]# bosboot -ad /dev/ipldevice
0301-168 bosboot: The current boot logical volume, /dev/hd5,
does not exist on /dev/hdisk17.
How can I enable AIX can to see the boot device in the SAN environment? We sucessfully apply same OS patching routine to another AIX server which is not connected to the SAN so I can verify that OS patches are good.
Grateful for any hints and tips.
Message was edited by: KCSCP Modified Symmetrix ID.
There is a section in powerpath install guide detailing how to set boot from san with powerpath correctly, it looks to me like you have missed a reboot or something in the steps. These issues can be tricky though Run EMC grab for support to have a look at. Without having all the information we could do more harm than good troubleshooting this on a forum.
tcmaij
2 Posts
1267
0
Posted March 10th, 2010 22:00
did you run "powermt config"?
regards,
Tjerk Maij