
UNSOLVED
Adding a second hard drive - Dell Dimension 5000 - Please help!
Hi i hope someone can help me on this board. I bought a new SATA drive to add to my Dell Dimension 5000 the first problem i have with it is i cannot fit the cover back on to the case because of the sata cable preventing it fitting. The second problem is even worse, when the drive is connected the pc seems to emit a throbbing sound. The weird thing is my old 4500 did this as well when i added a second drive. Is there anything that can be done?
Cheers
Cheers
Responses (1)
Solutions (0)

Kirbett
6 Posts
159
0
Posted May 16th, 2005 10:00
I can't help with the throbbing sound, I'm afraid, but I've had the same problem as you trying to fit the cable. We seem to be victims of this new BTX chassis format, which, while being super-quiet, really cramps the hard drive connectors. Ahead of receiving my new Dimension 5000, I'd purchased a SATA-to-IDE adaptor so I could add my old IDE drive to the machine, only having to scrap that idea once I opened up the Dell.
So I purchased a new SATA drive and started hunting for a cable that would fit. You need a SATA-cable with a right-angled connector at one end. There's a few online sites that sell them (including dabs.com). Of course, Sod's law rules, and the SATA-cable I received had a right-angle on it sure enough, but the WRONG way round! Thinking about it, it's obvious that the right-angle could go either way, but NONE of the suppliers that I've found specify which way round their cables go. Quite how they would describe it, I cannot imagine ... "hold the drive flat, facing the sockets, with the sockets on the right, then the RA connector should take the SATA cable UP rather than DOWN".
Fortunately, my cable length was 60cms which was JUST long enough to take the cable down into a cavity where it could it loop back up over itself and then up with the 1st drive cable to the system board connector, but it still gets cramped by a strut on the chassis lid. I'm not very happy with it, and am on the lookout for a correctly oriented replacement cable. In the meantime, I would suggest you look for an RA cable of at least 70cms in length to give you room to loop the cable back without cramping it.
I really do think this is an area where just a little bit of thought and documentation from Dell and the component suppliers could make getting this right so much easier.