UNSOLVED

kestrel1981

updated

22 days ago

K

kestrel1981

1 Rookie

•

2 Posts

•

7 Points

0

57

October 27th, 2026 18:12

M6800 CPU Fan not working

My CPU overheats and runs in restricted mode. The CPU fan is non functioning, so I replaced it with a new fan and thoroughly cleaned the vents with compressed air. But still doesn't function. At no point does it even try to spin. I have tested both the old and new fans in another sytem and both function normally. 

System diagnostics show errors with both the CPU and GPU fans. The GPU fan is spinning the whole time the laptop is powered on and I was unaware there might be an issue with it, but gives the same error code.

Error message in diagnostics say:

 

Error Code 2000-0511

Validation 106709

Msg: Fan - The [Processor Fan] fan failed to respond correctly

 

Technical support will need this information to diagnose the problem.

 

Has anybody any experience in fixing this issue?

  • ejn63

    12 Elder

    •

    31859 Posts

    •

    156307 Points

    7

    0

    Posted October 27th, 2026 19:24

    The fans need to be OE originals -- not third party replacements.  Are they?

     

  • kestrel1981

    1 Rookie

    •

    2 Posts

    •

    7 Points

    7

    0

    Posted October 27th, 2026 19:44

    @ejn63​ 

    Yes, both orignals. Both work fine in another system, which leads me to think that it might be a motherboard issue

  • ejn63

    12 Elder

    •

    31859 Posts

    •

    156307 Points

    6

    0

    Posted October 27th, 2026 21:07

    @kestrel1981 

     

    That is almost certainly the case. 

  • anne_droid

    6 Operator

    •

    2646 Posts

    •

    9726 Points

    4

    0

    Posted October 28th, 2026 10:25

    Hi

     

    • Faulty or partially damaged fan connector/header: A bent, corroded, or loose pin can supply enough power for detection but not enough for reliable fan drive.

    • Motherboard fan-driver circuit failure: The fan is powered/controlled from the motherboard; if its PWM driver, MOSFET, fuse, or related EC circuit has failed, a known-good fan will not spin.

    • BIOS/EC firmware or settings issue: An embedded-controller fault or outdated/corrupt BIOS can prevent fan startup or report the fan as absent.

    • Thermal-sensor or SIO reading fault: If the system believes temperatures are low, or cannot read the CPU/GPU thermal sensor, it may command zero fan RPM. This can still lead to overheating.

    But I suspect it is a fault for Dell to diagnose and repair, unless you want to replace the board yourself or a replacement refurb unit.

     

     

      Kind Regards  

                                         

      anne_droid

     

    User uploaded image