How do I install a Sata cable splitter into a Dell Precision T7910 (what
components need removing to access the Sata cables)
Hi,
I need to install a Sata cable splitter into my Dell Precision T7910 desktop. This cable will run to the removable side panel
To do this I have to access the Sata cables behind the hard drive cages.
I have previously opened and installed components into the T7910. However, I cannot find a guide on how to access the rear of the hard drive cages.
Also, looking inside my T7910 it is not clear how I would route the Sata cable splitter to the removable side panel of the desktop. I need to do this because I am installing an internal USB hub onto the inside of the removable T7910 side panel (more details below)
I do not want to start disassembling my T7910 in failed efforts to access the Sata cables.
So, I would be very grateful to any forum member who can offer some guidance in this matter.
Below are some photographs of the Dell Precision T7910 desktop that hopefullly visually explain my problem.
The reason for the Sata cable splitter is that I need to install a NZXT internal USB Hub 3 into my T7910. This requires a Sata power connection and I am not sure I have any free Sata cables I've already filled the lower hard drive cage with four IDE hard drives.
Even If I do have unused Sata cables I still need to connect one of these cables to the NZXT USB hub. Which means I still have to get behind the hard drive cages and then thread a Sata cable to the removable side panel.
I need the NZZXT hub to enable a WiFi pcie card. This card has to be plugged into the internal USB 2.0 slot. Unfortunately, this slot is already being used. I am installing the NZXT hub to expand the number of USB 2.0 slots I have on the motherboard.
You remove the right cover by removing 2 screws from the rear of the panel. This gives you access to the rear of the HD bays. See manual: Dell Precision Tower 7910 Owner's Manual
@BobL55 Thanks so much for the advice. I really appreciate it. I will need to run a cable from the HD bays to the other side of the desktop. Will I be able to do that without removing any components?
You need to study the manual. The 2 SATA connectors for the HDD are on the main board. With 4 HDD connected it is likely that both are used. There is a SATA connector for the optical drive bay which might be useable at the rear of the board. I have no idea whether this would fit the device you are considering installing or could be adapted to do so.
BobL55
2 Intern
•
101 Posts
0
0
Posted March 8th, 2026 18:58
You remove the right cover by removing 2 screws from the rear of the panel. This gives you access to the rear of the HD bays. See manual: Dell Precision Tower 7910 Owner's Manual