The server my powervault 124t is connected was recently upgraded from 2003 to 2008. Since the upgrade my backups are failing. I contacted the backup software company support and they say the problem is the tape back up. After doing so research I found an old (2 Years old) post that said the powervault 124t was not compatible to server 2008. The issue I am getting is exactly the same issue the orginal poster was recieving. When I check the compatibility matrix it says the tape drive is supported in server 2008. Can someone tell me if the device is compatible with server 2008.
According to the Dell PowerVault Compatibility Matrix, PV 124T is supported by Windows Server 2008.
Download this documentation here: <ADMIN NOTE: Broken link has been removed from this post by Dell>
Once you have downloaded the pdf file, refer to page 26, where you can see the PV 124T is supported under Windows Server 2008 and Windows Server 2008 R2 but with the firmware version V86 and driver version 2.6.2.0
If you need the firmware and driver, here they are:
Iwas so glad to find a new driver and link to the new firmware that actually work! Thank you!, but my joy was short lived! The firmware loaded without any issues, for both the drive and the library, the driver is also slightly newer than I have, date wise I am not 100% sure about the version. But I still get the driver issue in device manager for Win2008 r2:
Windows cannot verify the digital signature for the drivers required for this device. A recent hardware or software change might have installed a file that is signed incorrectly or damaged, or that might be malicious software from an unknown source. (Code 52)
I will power down and reboot the library properly tonight and reboot my server just to make sure and I will post that result tomorrow. But it doesnt look like I am going to have any more joy. I am looking to order a new library to replace my t124 which was fine when it was working. When it wouldnt work it was a bit of a donkey.
I found eventually the answer that worked for me. My tape library, tape drive and DVD-Rom all had a yellow exlimation mark in the device manager which was due to an unsigned driver which gave me a code 52 as above. I got this error after upgrading my 2003x64 Server to 2008R2. I have done 2 of my other Dell PE2950s in the same way and their DVD-Rom drives has/had the exact same issue. I eventually retraced it to the following: a gearaspiwdl driver that was common on the DVD, tape drive and Library (the latter 2 due to BackupExec) I removed the 3 filter keys @ their locations in the registry as per: "
DELL-Manfred W
166 Posts
751
0
Posted October 2nd, 2012 00:00
Hi mjmarriage
According to the Dell PowerVault Compatibility Matrix, PV 124T is supported by Windows Server 2008.
Download this documentation here: <ADMIN NOTE: Broken link has been removed from this post by Dell>
Once you have downloaded the pdf file, refer to page 26, where you can see the PV 124T is supported under Windows Server 2008 and Windows Server 2008 R2 but with the firmware version V86 and driver version 2.6.2.0
If you need the firmware and driver, here they are:
firmware
www.dell.com/.../powervault-124t
driver
www.dell.com/.../powervault-124t
Let us know how it goes.