
UNSOLVED
Changing RAID-5 with 18GB to 36GB drives
I have a PE 2450 with 3 18GB drives in a RAID-5 array (single container) on its PERC3-SI.
Since I can no longer get 18GB drives for the unit, I know that I can use a 36GB instead. And that only 18GB of the drive will be available when adding to the container and performing a rebuild of the RAID-5 set (preserving data).
My question is this: How can I get all of the drives to 36GB and use the added space?
If I take one drive as offline, replace with a 36, and rebuild...I'll waste 18GB on that drive. If I offline another and replace with a 36GB, same story. One more time and I'll have replaced all 3 18GB drives in the RAID-5 container with 36GB drives...but I'm assuming each drive will only be utilizing 18GB.
Or does that change with a container reconstruction on the last replaced 18GB unit? Or can it be done in some other way?
I'd like to minimize downtime, so doing this hot and succeeding with keeping the data in the container would be advantageous--for this server and others.
Thank you.
Responses (1)
Solutions (0)

Frank.Borrmann
2 Posts
111
0
Posted February 23rd, 2004 06:00
have the same server and disk sizes. After changed every drive one by one and take a rebuild every time all four disks are only 18GB. Very strange but real: the PERC recognized the new disk sizes only after a server reboot.
Now i can see 18GB unused per disk and Reconfiguration-Button in StorageManager does not work: "Operation failed". Trying to make a new ArrayGroup does not work also: "Operation failed".
DELL says, this doing is not supported, but for me this looks more like a program failure. For what reason are the appropriate buttons active and showing correct data? And other controllers like Mylex can do such things without any problem.
Hopefully DELL can fix these problems cause i don't want to build up our servers from scratch.
Regards,
Frank