According to my iDRAC card, my NICs have firmware version 13.1.10.
I'm successfully using SR-IOV on the X540 ports but not on the I350 ports.
I spoke with an Intel Engineer and he asked "could you please send along the output of lspci
-vvv -s 08:00.0 and lspci -vvv -s 08:00.1"? I provided him the information.
OK, that's what I suspected. Your config is missing the SR-IOV
capability structure. It would look something like this:
Capabilities: [160] Single Root I/O Virtualization (SR-IOV) IOVCap: Migration-, Interrupt Message Number: 000 IOVCtl: Enable- Migration- Interrupt- MSE- ARIHierarchy- IOVSta: Migration- Initial VFs: 8, Total VFs: 8, Number of VFs: 0, Function Dependency Link: 00 VF offset: 384, stride: 4, Device ID: 1520 Supported Page Size: 00000553, System Page Size: 00000001 VF Migration: offset: 00000000, BIR: 1
This is from a dump on an I350 controller on one of my lab systems.
This is a feature that is controlled by EEPROM settings. I'm guessing
that Dell has decided to defeature SR-IOV support for the I350 devices
on their daughter card. Or they could have made a mistake in
programming the EEPROM. In either case the attempt to enable SR-IOV on
devices without the SR-IOV capability structure will fail. I'd suggest
contacting your Dell supplier and getting further information from them.
Unfortunately, SR-IOV cannot be supported on the I350 ports of these quad port NDCs ( X540 + I350 ) and ( X520 + I350 ). However, new firmware have SR-IOV support on Intel(R) Gigabit 2P and 4P I350 adapters and it will be released from Dell in December 2013.
Why is that? Intel says the hardware is capable of it.
It's true that the I350 device itself is capable of it. The upstream port on the PCIe bus must support it too though.
The path through which those two I350 ports take on the PCIe bus doesn't support it. The two I350 ports go through a different path than the two X540 and X520 ports. The same applies to the X710/I350 rack NDC.
Kannan K
1 Rookie
•
16 Posts
2302
0
Posted November 25th, 2013 07:00
Hello !
Are you still looking for a solution? If yes, please provide the OS information.
Thanks,
Kannan