UNSOLVED

d-rick

updated

16 years ago

DR

d-rick

136 Posts

0

167793

August 29th, 2010 11:00

R710 stuck at initialzing UEFI / entry into LCC - how do i break out?

Hi,

 

I have an R710 that i'm trying to set up. When i power on the system, it is automatically dropping into booting into the LCC, and gets hung trying to load the UEFI screen (precursor to LCC screens).

 

There doesn't seem to be a way to interrupt this cycle, and after 5m or so i get the following error message:

unable to launch system services image

system halted!

 

looking here (http://support.dell.com/support/edocs/systems/pet110/en/HOM/HTML/about.htm#wp1183816) , it appears that i need to update the USC, but since i can't get it to boot...

 

any ideas?

 

  • d-rick

    136 Posts

    5404

    0

    Posted August 29th, 2010 11:00

    ok, i figured out how to break the boot cycle from idrac, still no idea how to fix the problem though...

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    5404

    0

    Posted August 30th, 2010 08:00

    If you can't boot to UEFI, change it to BIOS and update the USC, reboot, wait 20-30 minutes for the USC to be completely finished updating, reboot again (till it's finished on POST it'll say something about the system services not being available or so), and change it back to UEFI. After this you can see if you can install your OS again.

  • d-rick

    136 Posts

    5404

    0

    Posted August 30th, 2010 09:00

    Sorry, let me clarify.

    I can't boot into UEFI environment or the USC at all..

     

     

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    5405

    0

    Posted August 31st, 2010 08:00

    Ok, so once in the setup, change it to BIOS instead of UEFI and then see if it'll boot. If it does, install a (temporary) OS, use this to update the bios, ESM, etc, and then set it back to UEFI and see if you can reinstall the OS (on a GPT disk instead of an MBR disk).

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    5405

    0

    Posted August 31st, 2010 08:00

    If F2 won't get you into the setup, you probably want to open a case with Dell Poweredge support.

  • d-rick

    136 Posts

    5405

    0

    Posted August 31st, 2010 08:00

    i can get into the setup, but when i try and enter the lcc/ucs it doesn't work.

     

    i was thinking about installing an OS, then upgrading everything from OMSA, would that work?

  • d-rick

    136 Posts

    5405

    0

    Posted August 31st, 2010 11:00

    yeah, that is what i was thinking as well.

     

    will try and post results