UNSOLVED

kenmullins1

updated

8 years ago

0

1441

June 14th, 2018 06:00

Trunk Ports on N2000 series switches not working after

On our N2000 series switches, after upgrading to Firmware 6.5.1.3 with CPLD 20 (H/W ver 5) I noticed that my trunked ports stop working after unplugging a device (in this case an Access Point) then plugging it back in.  A reload (reboot) will re-enable the port, but shutdown, no shutdown has no effect.  I have only observed this on trunked ports.

I have seen this on two different stacked N2048 switches.  Our LinksPrinter shows a network connection but is unable to contact a DHCP server or connect with a fixed IP address.

  • vt1012

    212 Posts

    1323

    1

    Posted June 14th, 2018 07:00

    Hi Ken,

    I noticed there is a later firmware available (6.5.1.5) dated May 25, here: http://www.dell.com/support/home/us/en/19/product-support/product/networking-n2000-series/drivers.  It also appears to contain specific instructions for updating CPLD on stack members: "After upgrading the switches to FW version 6.5.1.1 and later (6.5.1.5), the CPLD can be updated to version 20 from CLI using the command - "update cpld". To update CPLD on stack members, run - 'devshell cpldUpdate' command from serial console."  After each stack member reboots, be sure to verify the CPLD has updated using the "show version" command.

    Hope this helps.