Non-disruptive firmware/software update of M8024k, M6348 and M6220 PowerConnect
switch stack?
We have multiple blade chassis (M1000e) with 2 M8024k (and some m6220 and M6348) PowerConnect Switches per chassis. We stack them together within the chassis. So we can configure both switches within one interface because it's one Virtual Chassis.
How will updates be handled? Is it possible to update the switches one-by-one? So my (mostly ESXi) hosts will be continuously available (on minimal half of the connections)? Or do I have to plan downtime on this chassis during the upgrade/update?
Is the update-proces of updating an PowerConnect stack with this switches be non-disruptive? Where to read the documentation on this?
But I can't find anything about non-disruptive... On the bottom of page 43, I read "Updating and rebooting the stack will take a few minutes longer than a single switch. If the bootcode is not required, then a simple reload command will need to be performed. After reload, the firmware upgrade is complete. "
So I'm afraid the whole stack will be unavailable during the reload/restart... Doe anyone have experience with the duration (downtime) of the upgrade process? How do you execute maintenance with high available Chassis/Stacks?
afurster
9 Posts
1088
0
Posted August 31st, 2015 14:00
I found more information on my question above. In the Data Sheet / White paper "Stacking Dell PowerConnect 10G Switches M8024k 8024 8024F" there is a Chapter named "Updating Firmware on a Stack" page 41 and further... See i.dell.com/.../Stacking-Dell-PowerConnect-10G-Switches-M8024k-8024-8024F.pdf
But I can't find anything about non-disruptive... On the bottom of page 43, I read "Updating and rebooting the stack will take a few minutes longer than a single switch. If the bootcode is not required, then a simple reload command will need to be performed. After reload, the firmware upgrade is complete. "
So I'm afraid the whole stack will be unavailable during the reload/restart... Doe anyone have experience with the duration (downtime) of the upgrade process? How do you execute maintenance with high available Chassis/Stacks?