UNSOLVED

seajewel

updated

12 years ago

S

seajewel

4 Posts

0

258922

November 18th, 2010 09:00

U2311h takes 1+min to turn on and menu button is permanently locked

I started using my new U2311H last week.  Yesterday, I noticed a really weird and annoying issue.  I had my PC turned on, and turned off my monitor to keep the music running.  Later, I turned on the monitor by hitting the power button, the power button lit up blue, but no screen showed up for a good minute or more.  During that time I tried turning off the monitor (the button was sticky in that i could hit the power button and the blue power light stays on instead of going off) i tried holding down the power button, the menu button, etc.  Eventually I got a picture.

Since then, my menu button is permanently locked.  I try holding down the button above the power button for 10+ secs, and sometimes it will show a little unlock icon, but again when i hit the menu button, nothing happens for a good 20-30 seconds, and then i get a lock icon on the screen.  It's almost as if the menu button is sticking or something.

When I turn monitor off then on, it takes ~ 75 secs for screen to show up.  When I reboot my computer, the screen, even when it had previously been turned on and showing a picture, will go black until "Starting Windows" shows up.  So I can no longer access my bios screen.. i may be able to, but i don't recall what button it is offhand, and since my screen is black through the entire booting screen with "hit F** for bios" etc, I'll have to look it up.

Is this a hardware issue?  could this be my PC, or is it my monitor?

I am using my monitor with the provided Dell DVI cable. My computer is new and is running 2X Nvidia 460 SLI with the most recent drivers on Windows 7 Professional O/S. The only change I made before noticing this issue was that I swapped out the really noisy high performance fan in my case for the default case fan because of noise levels. i did this carefully and my PC itself does not seem affected. Internal temperatures are good, idling around ~33 for the GPU up to like 75-80 when under load.

I also installed FanSpeed and tried to install cpu-z, but cpu-z wouldn't run for whatever reason. I have tested with FanSpeed turned off as well as on.

 

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    4814

    0

    Posted November 18th, 2010 22:00

    To unlock the monitor controls and get rid of the Lock, press and hold the monitor Menu button for about 10-15 seconds.
    Buttons =
    1 Preset Modes
    2 Brightness/Contrast
    3 Menu
    4 Exit
    5 Power

    * Power off the PC
    * Power off the monitor
    * Disconnect the power cord from the monitor
    * Disconnect all monitor cords from the PC (USB, DVI, VGA, DisplayPort, HDMI, etc.)
    * While disconnected, press and hold the monitor power button down for 5 seconds
    * Reconnect the DVI cord to the monitor and to the PC video card
    * Reconnect the power cord to the monitor
    * Power on the monitor if it does not power on by itself
    * Power on the PC
    * Press the monitor Input Source Select button and choose DVI


    DELL-Chris M (old account)

    #IWork4Dell

  • seajewel

    4 Posts

    4814

    0

    Posted November 18th, 2010 22:00

    i can try your second suggestion, but i assure you your hard unlock is not working.  while i was in fact using the "exit" button to try to unlock it (and it seems to, but it doesn't actually work on my monitor) i did this because the dell documentation, found at

    <ADMIN NOTE: Broken link has been removed from this post by Dell>

    says "Unlock function– Only hard unlock (Press and hold the button above power button for 10 sec)" 

    but i tried yours as well (using the 2nd above power button intsead of the one above) and it still only shows the locked icon.

  • DELL-Chris M

    Community Manager

    •

    56891 Posts

    •

    232143 Points

    4814

    0

    Posted November 20th, 2010 11:00

    Contact Support and get it replaced.


    DELL-Chris M (old account)

    #IWork4Dell

  • mds2004

    1 Message

    4814

    0

    Posted February 27th, 2011 14:00

    Just wanted to say thank you. I had both the issues with the lock and the insane delay of response when turning on but the solution of unplugging and holding the power button fixed it. Thanks. 

  • rasn

    7 Posts

    4814

    0

    Posted April 16th, 2011 06:00

    This helped for me too.

    Why is it happening in the first place? Actually I had to do it once more. Why? Looks like a SW bug, any firmware updates?

  • Finner42

    1 Message

    4814

    0

    Posted May 1st, 2011 23:00

    I too have had this problem with a recently bought U2311H. I tried the suggestions, and while they worked for a day or so, the problem came back - after leaving the monitor powered off over night, it takes 1+ min to turn back on. I have a 2nd (non-Dell) monitor on the computer which turns on immediately, so I know it's not the system taking a while to start.

    I took the Dell back to the shop and swapped it for a new one, but am still having the same problem.

    Does anyone know why this is happening?

  • rasn

    7 Posts

    4814

    0

    Posted May 8th, 2011 16:00

    My guess it takes given video cards and two monitors.

    I have a nvidia 9600 GT, same happenned to me with 2 displays connected. Now I disconnected the other and do not switch it off for the night and it looks like working for a few weeks now.

    Still I guess it is Dell to blame, definetely looks like a SW bug in the monitor, any firmware updates, Dell?

    (Once it is in the "bad" state, the slow on problem also happens with other computers).

     

  • Sentry13

    2 Posts

    4808

    0

    Posted May 17th, 2011 09:00

    I started having the exact same issue about a week ago with mine.  I will try the menu unlock method above tonight when I get home from work.  So are we saying that the slowness of the monitor coming on is related to the menu being locked or is that going to be a seperate issue?  capacitors maybe?  Or is it that the monitor is not set to DVI as a default and takes longer to display since it has to detect a signal coming in and then it shows up?

  • seajewel

    4 Posts

    4808

    0

    Posted May 17th, 2011 10:00

    i was the original poster. just dropping in to say that my problems resulted from using SpeedFan (or was it FanSpeed?). It's a program that controls your fans and monitors your temperatures.  For some reason, it was interacting badly with the U2311H monitor. after uninstalling, I have no issues whatsoever with my monitor.  I did contact the SpeedFan site, but they were unable to give me any answer as to why that was happening. 

  • rasn

    7 Posts

    721

    0

    Posted May 17th, 2011 12:00

    Hmm. I also have SpeedFan installed, so I guess it might have something to do with the problem indeed.

    Problem has not apperaed for me a while, but I also have not used SpeedFan for a while. Hmmm. I do not feel like testing it right now, did you actually test that SpeedFan?

    [joke on]

    Maybe instead of monitioring the temperature it temperatured the monitor .;)

    [joke off]