UNSOLVED

Laura3

updated

21 years ago

Closed

L

Laura3

19 Posts

0

11734

August 21st, 2005 00:00

Voice recognition software: Inspiron 8600

Hi,

Just wondering if anyone has used voice recognition software on their Inspiron 8600, and if there are any problems. I was thinking of Scansoft Dragon Naturally Speaking.

Thanks very much,
Laura
  • kwokPC

    77 Posts

    155

    0

    Posted August 21st, 2005 08:00

    I do not use "voice recognition" software, my wife does...

    dragon tried on (2) different motherboards using 2.4ghz 400fsb cpu, 2.8ghz 800fsb cpu and 3.2ghz 800fsb cpu - 2.4 combined w/512mb ram; while 2.8 & 3.2 combined w/2x512 (1gb ddr400) and have tried 3.2 w/2x1.0gb (2gb ddr400) ... hardware platform is critical or everything bogs down too much

    3.2+1gb was acceptable - 2gb also acceptable, but traded off 3.2oc'd to 3.7+1.0gb (water cooled)  as best compromise - office workstation

    I have tried on my own i5150 - 3.2ghz 533fsb 1.0gb ram 7k60 ... this system lags a little - needs higher fsb so dragon flows smoothly

    you have i8600 w/ 1.6 or 1.7 cpu + 400fsb + ?512mb ram?

    you really need 1.0gb ram and dragon will function - a new 2.0/533/2mb in a note will support dragon far better ... I removed from my i5150 ...

    further a hdd of 4200 2mb is not quite enough - for dragon to realtime for you

    voice recognition software needs fast hardware platform

     

  • bacillus

    2 Intern

    •

    14378 Posts

    155

    0

    Posted August 21st, 2005 09:00

    I sometimes use Dragon version 7 on my 6000 which has a 1.86Ghz cpu & a gig of ram and am quite satisfied with its performance.

    version 8 is supposed to be better but as I have never used it, I can't really make any helpful comments!
  • Laura3

    19 Posts

    155

    0

    Posted August 21st, 2005 16:00

    Hi,
    Thanks for replying. I am beginning to see my laptop may not have enough power. I'm not a computer expert...but I found the following info on my dell: pentium 1.40 ghz 600 mhs hard drive, 1400 mhz processor, current cpu speed 600 mhz, 512 RAM.

    Laura
  • bacillus

    2 Intern

    •

    14378 Posts

    155

    0

    Posted August 21st, 2005 17:00

    your laptop has more than the minimum recommended cpu horsepower & ram for using Dragon.

    XP uses speedstep which throttles back the cpu speed to a minimum if the full processing power is not needed hence you are seeing "current cpu speed 600 mhz". if full cpu power is needed then it will ramp up to the rated 1.4GHz.