UNSOLVED

whiteashcm1

updated

21 years ago

W

whiteashcm1

133 Posts

0

8655

July 2nd, 2005 05:00

xps gen 3 with geforce 7800gtx 256mg

i installed a xfx 7800gtx card in my gen 3.. the stock clock speeds out of the box are 450/1250.. i am using the 80.40 version driver with the coolbits over clock page enabled.. the clock speeds show 275/1250 but when i enable the manual overclock and switch from advanced 2d to performance 3d then the speeds show correctly at 450/1250.. does anybody know why the clock speeds dont show correctly on the overclock page when its set to no overclocking??????  is the driver not reading the speeds correctly or does this new gpu have to be set on performance 3d??? i tried the 77.50, 77.72 and the current driver and they all display the speeds the same.... anybody have a clue??               P/S, benchmarks are the same with advanced 2d and performance 3d...
  • fiber4now

    164 Posts

    369

    0

    Posted July 2nd, 2005 16:00

    So you finely scratched that upgrade itch with the 7800 GTX, I do not believe their will be many on this board that can advice you on the best driver for your card, I believe you should post a thread on th XFX board or Driver Heaven.

     As for all new card releases the drivers that are out at release are not the very best optimized drivers for the latest card so be patiant and read as much as you can about your card, Xbit Labs have a great two part review of the 7800 GTX but does not mention problems like you have descibed with driver that they tested card with.

     

     
  • fiber4now

    164 Posts

    369

    0

    Posted July 2nd, 2005 16:00

    repeat message

    Message Edited by fiber4now on 07-02-2005 12:31 PM

  • whiteashcm1

    133 Posts

    369

    0

    Posted July 2nd, 2005 18:00

    yeah the 7800 looked good so i thought i would give it a try... i'm just trying to figure out why the gpu core speed doesnt read correctly on the overclock page in the control panel....
  • rick000

    2 Intern

    •

    623 Posts

    369

    0

    Posted July 3rd, 2005 00:00

  • Mad Pistol

    93 Posts

    369

    0

    Posted July 5th, 2005 15:00

    you guys must be newbs to this.
     
    If you check the 2D settings, they are almost always lower than 3D settings. that means that if you are playing a game, it will be at the listed settings in the 3D Performance tab (your card's listed settings) 2D mode is virtually a "power saver" that will run if you're not doing gaming.
     
    Am I missing some detail here, or is what I read correct? if it is, then you have nothing to worry about.