
UNSOLVED
T
twoormorechars
2 Posts
0
35094
August 20th, 2003 01:00
V-E-R-Y S-L-O-W POST (power-on self-test)
Windows 2000 crashed and I had to hit the power button on this Dimension XPS T500. Nothing unusual about that. However, when it powered up the POST ran very slowly. Very slowly as in being able to see the RAM count: 7 MB (pause) 11 MB (pause) 15 MB (pause) . . . .
The BIOS setup screens are similarly slow. The screen is painted in three distinct steps, first the top third, pause, then the middle third, pause, then the bottom. There is a delay of a couple of seconds between pressing the arrow key and the highlight moving.
Here's the strangest part: Once it finally boots, it seems to run just fine.
Tried several re-boots, both warm and cold, with the same results: Amazingly slow boot sequence, but once Windows starts it runs at normal speed.
Any ideas?
Thanks in advance.
Responses (4)
Solutions (0)
twoormorechars
2 Posts
1413
0
Posted August 20th, 2003 05:00
Power seems unlikely to me -- why would it affect only the POST?
Still, your mention of USB reminded me that, since the last "normal" boot, I had plugged in a USB hub. Unplugged it, and now it boots fine.
Anybody out there know what might really be happening?
A few more details for completeness' sake: There had been a USB keyboard/mouse and a USB printer plugged into the computer's USB ports. I removed the printer, plugged it into a hub (an externally powered one, which already had another printer and a scanner plugged into it), and plugged the hub into the computer's USB port and it took forever to boot. All the peripherals worked fine, and the computer ran normally once Windows started; it was just extremely slow during the POST (and also while running the BIOS setup program).
Thanks All.
One thing which comes to mind is the BIOS setting for USB emulation.
It allows the BIOS to provide USB support up to the time Windows takes control and is to allow USB peripherals to function (like USB mice and keyboards) during POST.
Try changing the setting. The worst that would happen I think, would be a keyboard error at bootup if you have a USB keyboard.
It might end the slow POST.
I could envision a very active active USB peripheral bogging the BIOS emulation down though you'd think the POST wouldn't be affected. Remember, until Windows comes up, the system is running in real mode and thus relying on very slow DOS-style I/O methods. Thus is why coming out of hibernation is typically so slow. No high-speed hard drive support thus slowing down the reading of the hibernation file. Though I think Dell recently has been adding better high-speed support in the BIOS to address that.
Until the system's in protected mode, all I/O must be done through the BIOS using legacy techniques.
Hope this helps!
Dave

ezattsanii
14 Posts
1413
0
Posted August 20th, 2003 04:00
You may not be getting enough power at boot-up. If you have a UPS, try to bypass it and see if that makes a difference. If you have an Ultra ATA card, or power hungry USB devices, you may also remove and see if the slow POST changes. If these do not help, memory or hard disk may have problems. In my case and for three different computers, once it was due to UPS, once to Ultra66/ USB, and once to a failing hard disk. The failing hard disk caused very slow login (10 Min) but POST was OK.