
UNSOLVED
Using Centurion Guard on an Optiplex 755
I have a computer lab at a public library where I want to install a couple of Optiplex PCs. We have several Gateway's that are old and need to go away. These Gateways, use Centurion Guard to "lock down" the PC from changes.
The Centurion Guard used the floppy drive interface and a molex connection for power. The molex connector I think is not a huge problem, however I am uncertain about the floppy drive connector. On the Centurion Guard there is a 34 pin connector. CenturionTechnologies tell me I should be OK as long as the connector on the motherboard to the floppy drive is 40 pins and can support the 34 pin connection on the Centurion Gurard. The question is, are these Dells standarized on a 40 pin floppy drive connector or is there another kind of connector that Dell uses that could change this plan?
Is there anyone out there that uses Dells with a Centurion Guard solution?
Responses (1)
Solutions (0)

Dev Mgr
6 Operator
•
9308 Posts
•
3 Points
103
0
Posted August 28th, 2008 19:00
Per the online specs of the 755 (tower) under connectors it says that the motherboard has a 34-pin floppy drive connector. It doesn't have an IDE/ATA connector (the only 40-pin device is the cable to the front panel, but this is not for drives at all).
If I'm understanding your post correctly I think the onboard 34-pin connector is all you really need (other than maybe a floppy drive cable to connect whatever kind of device Centurion Guard uses).