
UNSOLVED
Hey all! I have an X1900 XTX - Upgrade Time!
Hey all! I have an X1900 XTX as you can see from my signature, and I'd like to upgrade (do not try and argue me out of this, I just want some help :) ) So, what should I do? X1900 XTX's are cheap enough these days on ebay, so would I be able to buy one and set up crossfire? If so, how, and what complications would I face? Of course, I could also try going for a new card all together. I do not want to spend a whole lot though, X1900 XTXs can go for about $150 on ebay. Ideas?
Message Edited by griffy208 on 06-27-2007 04:35 PM
Message Edited by griffy208 on 06-27-2007 04:35 PM
Responses (3)
Solutions (0)
- Not having a 1900 CF card to test, I can't say for sure but I'd think it would be easier-- as long as you first use a dell dual-x1900 driver pack that would allow you to install them both in one shot before upgrading to the latest drivers on ati's site. Check under the xps 700 or xps 600 to find a driver pack for dual 1900's becuase there isn't one listed for the xps 710. The only thing listed for the 710 is a driver for dual x1950's, and based on what I found under XP, the 1950 install from dell won't recognize the 1900.Under vista, the 1950 pack does recognize the 1900- so using evilping's directions to install both with one pack works fine.Do NOT try the vista package for the dual x1950's in XP, thinking it might work. It won't, already tried it.You have to go through all this work because something special in the dell drivers allows crossfire to be an option in the catalyst control center on the nvidia motherboard'd xps 700 series.The updated driver pack that you'll get from ati picks up on this special sauce and allows crossfire to stay enabled as you upgrade your drivers. This is an educated guess based on evilping's findings in the earlier thread and what I've seen myself. If you try to install the ati drivers first without using the dell drivers to establish the 'special sauce', the ati driver pack doesn't see whatever it's looking for and thus hides the crossfire option in catalyst. So while your hardware will be installed, you won't be able to enable crossfire, which wouldn't be good.To see what kind of performance boost, use the links below and select your benchmarkhttp://www23.tomshardware.com/graphics.html for singlecard performancehttp://www23.tomshardware.com/graphics_sli2007.html for sli/crossfire performancefor example. x1900xtx in crossfire gets 68 frames per second and gets 60 fps as a single card in battlefield 2142 at 1280x1024--- but if you increase the resolution to 1900x1200 and turn on all the eye candy, all of sudden you are getting 47 FPS in crossfire and 32 in single card. Check by title and by resolution when doing comparisons, because at lower resolutions, your bottleneck for frame rate will be the cpu, not graphics-- which is why you saw a measly 10% performance increase at 12x10 in BF2142. If you are running a 24" monitor like I am and like 1900x1200, you gotta look at crossfire, because you'll see the 50% increase in frame rates using crossfire.Theoretically, with your processor not being a bottleneck. you should get almost double the performance from 2 cards vs 1, and the 3dmark bears this out b/c at 1900x1200 it shows 1300 'points' for singlecard and 2450 'points' for crossfire. YMMV.
Message Edited by waxman43 on 06-29-2007 11:23 PM

waxman43
6 Posts
206
0
Posted June 29th, 2007 06:00