Monica Jade

updated

15 years ago

0

14504

June 16th, 2011 17:00

Dimmension 4500 won't boot, Please Help!

I need to Reinstall Windows XP on my brother's Dim4500 and even though he has is Reinstallation Disk, I did ctrl+F11, but I should have known the PC was too old for that. Now it says Please Reboot and Select a Proper Boot device or Insert Boot Media, and the CD tray won't open (but ther's nothing wrong with the CD Tray). What did I do with ctrl+F11? Windows is still there and working, I just needed to reinstall. Now I can't get to it.

  • Compgeke

    48 Posts

    889

    1

    Posted June 18th, 2011 12:00

    Make sure the system is sitting with the disk drive horizontally. If it's got one of those damn Samsung drives they don't open vertically for some reason.

    If it's sitting horizontally take a straightened out paper clip and push it into the small hole below the disk try to open the drive. With any luck it will just be because the disk drive hasn't been opened in a while and it got stuck.

    Also, the hard drive message. The hard drive is dead. That means that any pictures, documents, etc are lost unless you have backups. That click is the hard drive (it's dead) and that also explains the reason why it's telling you the hard drive isn't there. You will need a new hard drive which you can grab one for like $50 and use the Windows install CD to reinstall Windows XP (or newer if you upgraded). The hard drive you will need is a 3.5" IDE drive, ATA100 or 133.

  • Compgeke

    48 Posts

    889

    1

    Posted June 18th, 2011 13:00

    No, the keypress didn't do it. The only way you could've done it your self is if you dropped the computer or got a crazy idea to throw the drive across the driveway (like I did).

    The beige Dell (cream color) will for sure have an IDE hard drive. If you don't use it anymore take the hard drive out and installing into the 4500 and use the Windows install disk to reinstall Windows. The 4500 will be 10 times faster than any Celeron (which is probably what the beige one has). The drive swapping will probably take 10 mins to do and it's fairly easy using the Dell documentation for the model of computer. Depending on the age of the Beige one it may even have the green drive rails that the 4500 has that would make the swap very easy.

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    889

    0

    Posted June 16th, 2011 18:00

    Osprey your link doesn't work right...

    Ron

  • osprey4

    6 Operator

    •

    34230 Posts

    889

    0

    Posted June 16th, 2011 18:00

    Hi Monica Jade,

    Sounds like a problem with the boot manager on the drive. You can try the trick described here to fix this problem.

  • 889

    0

    Posted June 16th, 2011 18:00

    Yes, the link is not a link, osprey, but thank you.

    Edit: I just got into the Setup BIOS, and the Boot Priority only sees a Removable Dev, and the CD Rom Drive, that's all is on the screen there. Did I disable the Hard Drive by doing ctrl+F11? I don't know what's supposed to be there.............

    Edit2: Yes, the BIOS only sees the Floppy Drive and the CD-ROM Drive, not the Hard Drive...

  • 889

    0

    Posted June 17th, 2011 10:00

    Can anyone please help? The computer no longer sees the Hard Drive.

  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    889

    0

    Posted June 17th, 2011 12:00

    What color are the 4 diagnostic LEDs on rear of the tower when it won't boot? Look up error codes here. Any beeps from the tower at boot?

    If you put a bootable CD in the optical drive (eg, your Dell Windows Reinstallation CD) will it boot? Put the disk in the drive and close the drawer, reboot and press F12. Select the "boot from CD" option.

    If you're comfortable working inside the case, you can try this:

    Power off and unplug

    Press/hold power button on tower for ~15 sec

    Open the case and carefully reseat the flat ribbon cable connector to the hard drive. The ribbon cable should have a red or pink stripe on one edge. Make sure you see it before you disconnect the cable and be sure it's on the same side when you reconnect the cable.

    Reseat the power cable connection to the drive too 

    Then remove the motherboard battery and press/hold power button again for ~30 sec.

    Reinstall the battery (right-side-up!) and close the case.

    See if it will boot now with only mouse, monitor and keyboard attached.

    Ron

     

  • 889

    0

    Posted June 18th, 2011 11:00

    All the lights are green on the back. Since the Computer's been messed up, the CD Drive can't open. It works and it tries to open, but it doesn't open at all.. We replaced that CD drive a long time ago and it's not the one that came with the computer. There are no beeping from the computer, but it does go Cuh-lick-Cuh-lick-Cuh-lick-Cuh-lick in a weird pattern like something inside is clicking around. I never noticed if it's always done that or not. I thought it was the CD ROM drive but it does that even if I don't try to open it.

    I'm not that comfortable to work on the case, but I will if I have to and there's nothing else that can be done.

  • 889

    0

    Posted June 18th, 2011 12:00

    Ohhh...the Hard Drive's dead? I killed it by trying ctrl+F11? None of out PCs have ever had a hard drive die. My brother had just saved everything because I was about to reinstall Windows. Did the keypresses truly do that to it? Is it worth trying the battery thing and possibley messing up something else or are you positive the 4 cuh-lick pattern means it's dead?

    We still have a cream-colored Dell that came with Win-ME (now runs XP) that works like a turtle with three broken legs, but it's still alive (or was the last time anyone turned it on)

    I'm kinda shocked. Was it me, or was it the most horrible coincidence?

  • 179

    0

    Posted June 18th, 2011 14:00

    Thank you, Compgeke. I think it happened right as I pressed the keys. It kind of froze on the black and white lines across the bottom, and I can't remember if I turned it off and back on or just let it work itself out, but I remember it stayed frozen for at least 30 seconds, then the CD drive wouldn't open after that and it gave that message about giving it something to boot from. I saw it happen so I really thought the keys did it so thanks for letting me know that wasn't it.