
Solved!
Go to SolutionResponses (13)
Solutions (0)
shesagordie
12 Elder
•
46017 Posts
884
1
Posted December 29th, 2008 08:00
ridlin04
You are welcome. :emotion-2:
Bev.
LANNY_589b62
77 Posts
884
1
Posted December 29th, 2008 17:00
My Dimension 2400 (Celeron 2.6 GHz CPU) has four (4) Diagnostic Lights, on the back panel. A, B, C & D. They are located just below the connectors where you plug in the Mouse and Keyboard. On mine, they are all Yellow. I think that means the motherboard has been damaged. Some of the Diagnostic Light combinations are explained in the Owners Manual. If you don't have that, you can probably find it here on the Dell Support site. Also, you may want to run the Dell Diagnostics on the CD that came with the box, on the motherboard, RAM, etc.,if you have that, if not, you can probably Download it from the Dell Support site.shesagordie
12 Elder
•
46017 Posts
884
1
Posted December 29th, 2008 18:00
Ok
Replaced the psu and nothing
Green light comes on but nothing else
took all cards/cables/memory with no beeps I guess its the mobo
just need to know what mobo would replace this one
thanks
ridlin04
If you have removed all the PCI cards, the video card [if applicable], memory, all peripherals, disconnect the data and power cables to all the drives, check that the front panel cable is connected to motherboard, with nothing else connected to the system and power the system on.
Then if you do not get any beep codes or diagnostic lights on the back panel, it would appear that motherboard has died.You would need a Dell Dimension 2400 motherboard, this can be purchased from HERE, or you may find a motherboard on eBay that costs less.
Bev.
polarpal99
2 Posts
884
1
Posted February 6th, 2009 09:00
A related question regarding the 4-pin connection (J10, per http://support.dell.com/support/edocs/systems/dim2400/en/F75560LRs.pdf diagram, page 51/100): what is it for and is it necessary? (My replacement PSU is a 20 not a 20+4).
shesagordie
12 Elder
•
46017 Posts
884
1
Posted February 6th, 2009 12:00
polarpal99
Yes, the ATX 12v [J10] 4-pin connector is necessary, it supplies power to the P-4 processor.
Bev.
polarpal99
2 Posts
884
1
Posted February 6th, 2009 15:00
Yep. I expected it is necessary. Guess I'll be getting a 4-pin Molex-to-12V adapter cable (like http://www.playtool.com/pages/psuconnectors/12v4pinadapter.jpg). Thanks!
shesagordie
12 Elder
•
46017 Posts
214
1
Posted February 6th, 2009 17:00
polarpal99
You are welcome.
Bev.

shesagordie
12 Elder
•
46017 Posts
884
1
Posted December 28th, 2008 21:00
ridlin04
As the D-2400 has an open back, you can use most generic standard ATX PSU, with or without, the on/off switch and either a 20-pin or 20+4-pin main motherboard power connector and this power supply can be purchased from either a local computer or online store.
Bev.