
UNSOLVED
Dead XPS 710 motherboard replacement (710/720)
Dear All,
Only joined today and first post. Surprising as I have had SO much trouble with this machine over the last 4 years.
My wife wants to throw it away as it has been so unreliable (many nights pain and forums) but for once I have to agree. yesterday the machine decided it would not boot to bios at all and all the machine does is run all fans flat out with no diagnosis lights or sounds even if I remove all peripherals and a constant amber light.
So I think dead mobo. Question is I cant find a straight 710 board anywhere in the UK even on ebay? I spoke with Dell today who offered me a 710/720 board (UT868) but from what I see the 720 board is part GT661?
They have charged me a very questionable £301 for this board (4 years old???)
I have three questions really and would appreciate help/views
1) How easy is the mobo change, is there any guides/videos online. I have now asked verbally and via email (3 times) that I am not convinced the board will work without the Front and Rear I/O panels and cables.
2) Is this the right part they have ordered me?
3) I just wanted the quickest route to repair as my wife has pictures on there and I didnt want to risk an ATX rebuild and lose access to the drives due to the proprietry RAID controller which I assume is on the board? (I have four drives 2 system drives as raid 0 and two data drives as raid 1). Did I make the right decision, could I have bought a new ATX case/board/PS and would one of the raid 1 drives just plugged in (I have a purchased WIn7 OS) or better still would all the drives have fired up without dells raid controller?
Responses (6)
Solutions (0)
There were problems with the 710 boards and a replacement program to make them 720's
I would say replace with a 720 motherboard.
You will also need one of these depending on the color of your system
XU556 Rear I/O Panel Assembly, Metal, XPS 720 ASSY,PNL,REAR,I/O,MET,XPS,720 0 1 0 Yes 0
XU567 Front I/O Panel Assembly, Black, XPS 720 ASSY,PNL,FRT,I/O,BLK,XPS,720 0 0 1 Yes 0
XU695 Front I/O Panel Assembly, Red, XPS 720 ASSY,PNL,FRT,I/O,RED,XPS,720 0 0 1 Yes 0System Board
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide Removing the System Board
NOTICE: The system board and metal tray are connected and are removed as one piece. - Follow the procedures in Before You Begin.
- Remove the computer cover (see Removing the Computer Cover).
<ADMIN NOTE: Broken link has been removed from this post by Dell>
- Disconnect the fan cable from the FAN_CAGE connector on the system board (see System Board Components).
- Remove any full-length expansion cards (see Removing PCI and PCI Express Cards).
<ADMIN NOTE: Broken link has been removed from this post by Dell>
- Remove the two screws securing the card fan assembly, then remove the assembly and set it aside.
1
screw (2)
2
card fan assembly
3
fan connector
- Remove any additional components that may restrict access to the system board.
- Disconnect all cables from the system board.
NOTICE: If you are replacing the system board, visually compare the replacement system board to the existing system board to make sure that you have the correct part. - Remove the two screws securing the system board assembly to the chassis, then pull on the two tabs to slide the system board assembly towards the front of the computer.
1
screw (2)
2
tabs
NOTICE: The system board and metal tray are connected and are removed as one piece. - Carefully, lift the system board assembly up and out of the computer.
Installing the System Board
NOTICE: The system board and metal tray are connected and are installed as one piece. NOTICE: If you are replacing the system board, visually compare the replacement system board to the existing system board to make sure that you have the correct part. NOTE: Some components and connectors on replacement system boards may be in different locations than corresponding connectors on the existing system board. NOTE: Jumper settings on replacement system boards are preset by the factory. - Transfer components from the existing system board to the replacement system board, if applicable.
- Orient the system board assembly by aligning the notches on the bottom of the assembly with the tabs on the computer.
- Slide the system board assembly toward the back of the computer until the assembly clicks into place.
- Replace the two screws to secure the system board assembly to the chassis.
- Align the screw holes on the card fan assembly with the screw holes on the system board assembly, then replace the two screws to secure the card fan assembly.
- Connect the fan cable to the FAN_CAGE connector on the system board (see System Board Components).
- Replace any expansion cards that you removed (see Installing PCI and PCI Express Cards).
<ADMIN NOTE: Broken link has been removed from this post by Dell>
- Replace any additional components that you removed from the system board.
- Reconnect all cables to the system board.
- Replace the computer cover (see Replacing the Computer Cover).
<ADMIN NOTE: Broken link has been removed from this post by Dell>
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your computer. - Connect your computer and devices to electrical outlets, and then turn them on.
- Flash the system BIOS, as needed.
NOTE: For information on flashing the system BIOS, see support.dell.com. http://www.jasemccarty.com/dell/xps720partslist.htm
XPS 720 Parts List
I did not compile this list, and therefore am not responsible if the part numbers are incorrect.
- Follow the procedures in Before You Begin.
I understand that your system is 4 years old so even if your warranty expired you can call Dell to extend your warranty (maximum 5 years from the date you purchased it). You'll still get about 1 year of warranty and the price for the remaining warranty should be half of what they are asking for the motherboard and if you chose onsite warranty they'll send their technician and replace it for you. That's valid in US hopefully is the same in UK.
shesagordie
12 Elder
•
46017 Posts
1972
0
Posted September 8th, 2014 23:00
Bank_601
Have you read the posts Here:
http://en.community.dell.com/support-forums/desktop/f/3514/p/19388275/19901903#19901903
http://en.community.dell.com/support-forums/desktop/f/3514/p/19447622/20099580#20099580
Bev.

RoHe
12 Elder
•
45230 Posts
•
172625 Points
1972
0
Posted July 8th, 2011 11:00
According the manual:
If the power light is steady amber, a device may be malfunctioning or incorrectly installed.
So try this:
Power off and unplug
Press/hold power button on tower for ~15 sec
Open the case and remove the motherboard battery. Then press/hold power button for ~30 sec
Reseat the RAM modules and all cards.
Reinstall the battery (right-side-up!) and see if it will boot now with only mouse, monitor and keyboard connected. And if the battery is more than 2-3 years old, it might be a good idea to install a new one.
If that doesn't help, you may need to strip it down to bare essentials to see if you can ID the bum part(s).
As for replacing the mobo, the manual doesn't give any specific details, but it does provide instructions to remove most everything else, which you will have to do in order to move the hardware onto the new board. The instructions for removing the board from the 720 are here
<ADMIN NOTE: Broken link has been removed from this post by Dell>
and may be similar to the 710.
Dell typically makes changes to motherboards along the way, and each revision usually has a new part number. So if they tell you that's the right one, I guess you have to assume they know their stuff. :emotion-4: The price seems steep...
Ron