Hello, I bought Dell 5430, . The laptop is fine, everything is updated - bios, drivers. What I understood supports Gen 4x4 NVME and i bought Lexar NM790 1 tb but the speed is half than expected. Anyone with solution for this problem. Thanks
If you look at the manual I linked below, Dell offers different motherboard options depending on customers configurations. I suspect that you have the board with storage option up to Gen 3 based on your original storage selection.
@Chino de Oro I bought it used, it was with Gen 3 256gb, i asked the shop and they said that it supports Gen 4, but sadly my new Gen 4 m2 shows the results from the attached.
The Dell 5430 Gen4 laptop is compatible with NVMe drives, which offer faster data transfer speeds compared to traditional SATA drives. This means you can experience quicker boot times, faster file transfers, and improved overall performance when using NVMe storage.
I understand your frustration with the slower than expected NVMe speeds on your Dell 5430. Here are some troubleshooting steps:
Check BIOS Settings: Ensure NVMe mode is set to "RAID On" or "AHCI" in the BIOS for maximum performance.
Verify PCIe Lane Configuration: In the BIOS, confirm the PCIe lane configuration for the NVMe slot is set to x4 (if possible).
Test with Different Benchmark: Try a different benchmark tool to rule out software limitations. CrystalDiskMark is a popular option.
Contact Dell Support: If the above steps don't work, contact Dell support to see if there are any known limitations or firmware updates specific to your laptop model and NVMe drive combination.
Here's hoping this helps you achieve the expected speeds from your NVMe drive!
Chino de Oro
11 Legend
•
8554 Posts
•
47161 Points
0
0
Posted May 31st, 2024 12:00
If you look at the manual I linked below, Dell offers different motherboard options depending on customers configurations. I suspect that you have the board with storage option up to Gen 3 based on your original storage selection.
https://dl.dell.com/content/manual25345577-latitude-5430-setup-and-specifications.pdf?language=en-us